Whirlpool WRV976FDEM Use & Care Guide - Page 18
Using the Controls
View all Whirlpool WRV976FDEM manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
Using the Controls The controls are located above the external dispenser. View Temperature Set Points 1. Press and hold TEMP for 3 seconds to activate Temperature mode. NOTE: To view temperature in degrees Celsius, press the LIGHT button, under Units, when adjust mode is activated. To return the display setting to Fahrenheit, press the LIGHT button again. When Temperature mode is activated, press TEMP to toggle between Fridge and Freezer. The display will show the temperature set point of the selected compartment and temperature adjusting information will appear on the display screen. Recommended Refrigerator Temperature IMPORTANT: The display screen on the dispenser control panel will turn off automatically and enter "sleep" mode when the control buttons and dispenser paddles have not been used for 2 minutes or more. Press any control button to reactivate the display screen. The home screen will appear as shown. Recommended Freezer Temperature Viewing and Adjusting Temperature Set Points For your convenience, your refrigerator and freezer controls are preset at the factory. When you first install your refrigerator, make sure that the controls are still set to the recommended set points. The factory recommended set points are 37°F (3°C) for the refrigerator and 0°F (-18°C) for the freezer. IMPORTANT: ■ Wait 24 hours before you put food into the refrigerator. If you add food before the refrigerator has cooled completely, your food may spoil. NOTE: Adjusting the set points to a colder than recommended setting will not cool the compartments any faster. ■ If the temperature is too warm or too cold in the refrigerator or freezer, first check the air vents to be sure they are not blocked before adjusting the controls. ■ The recommended settings should be correct for normal household use. The controls are set correctly when milk or juice is as cold as you like and when ice cream is firm. NOTE: Areas such as a garage, basement, or porch may have higher humidity or extreme temperatures. You may need to adjust the temperature away from the recommended settings to accommodate for these conditions. ■ Wait at least 24 hours between adjustments. Recheck the temperatures before other adjustments are made. Adjust Temperature Set Points Refrigerator set point range: 33°F to 42°F (0°C to 5.5°C). Freezer set point range: -5°F to 5°F (-21°C to -15°C). 1. When Temperature mode is activated, press TEMP to select the Refrigerator zone. The display will show the temperature set point of the selected compartment as shown. 2. Press LOCK to raise the set point, or press OPTIONS to lower the set point. 3. When you have finished viewing (and adjusting if desired) the refrigerator set point, press TEMP, under Select Zone, to change the display to show the freezer set point. When the zone has been changed, "FREEZER" appears on the display screen. 4. Press the LOCK button to raise the set point, or press the OPTIONS button to lower the set point. Save/Confirm Temperature Settings ■ When you have finished adjusting both the refrigerator and freezer set points, press MEASURED FILL to confirm and to save the settings. NOTE: To exit Temperature mode without saving changes, press the ICE/WATER button under Back at any time, or allow about 60 seconds of inactivity. The temperature mode will turn off automatically and return to the normal screen. 18