Whirlpool WRX986SIHZ Installation Instructions - Page 7
Remove Drawer Front, Replace Drawer Front, Reconnect Wiring, Freezer Drawer
![]() |
View all Whirlpool WRX986SIHZ manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
3. On one side of the wiring connector, insert the screwdriver blade between the connector tab and the connector to release. Repeat for the opposite side. Pull the wiring connector apart. Reconnect Wiring 1. Align the two ends of the wiring connector and push them together until you hear a "click" sound and feel the tabs snap into place on the connector. 2. Gently pull on the wiring connection to ensure the wiring connection is completely seated. Replace the wiring cover. NOTE: The wiring connection must be complete for the drawer temperature control to operate. Remove Drawer Front 1. Using a ¹⁄₄" hex head nut driver, remove the two bottom screws (one on each side) attaching the drawer front to the drawer glides. 2. Using ¹⁄₄" hex head nut driver, loosen the two top screws (one on each side) attaching the drawer front to the drawer glides. NOTE: Loosen the screws three to four turns. Keep the screws in the drawer front. 3. Lift the drawer front up and off the drawer glide brackets. A 3. Replace the interior bin. Freezer Drawer Remove Drawer Front 1. Open the freezer drawer to its full extension. 2. Loosen the two top screws that fasten the drawer front to the drawer glides. The two screws (one on the left-hand side and one on the right-hand side) are located inside the drawer front. 3. Lift up on the drawer front to release the plastic studs from the drawer glide bracket slots. B C A A. Loosen top screws B. Drawer glide bracket C. Remove bottom screws 4. Slide the drawer glides back into the refrigerator. Replace Drawer Front 1. Pull out the drawer glides until they are fully extended. 2. Lower the loosened screws in the top of the drawer front into the upper notches in the drawer glides. NOTE: It helps if one person holds the drawer glides steady while another person aligns the drawer front and inserts the screws into the notches. 3. Align the holes in the bottom of the drawer front with the holes in the bottom of the drawer glides and fasten with the screws removed earlier. 4. Tighten the two top screws. A. Drawer glide bracket slots 4. Slide the drawer glides back into the freezer. 7
![](/manual_guide/products/whirlpool-wrx986sihv-installation-instructions-18e9972/7.png)