Whirlpool WRX986SIHZ Owners Manual - Page 13
Install Air Filter
View all Whirlpool WRX986SIHZ manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
The Water Filter Status Light Press OPTIONS on the control panel to launch the Options menu. Press OPTIONS, under Filter Status, again to display the percentage of filter life remaining (from 99% to 0%). Press ICE/ WATER, under Back, to return to the Normal screen. The water filter status lights will help you know when to change your water filter. ■ ORDER FILTER (yellow) - it is almost time to change the water filter. While you are dispensing water, "Order Filter" will blink seven times and sound an alert tone three times. ■ REPLACE FILTER (red) - Replace the water filter. While you are dispensing water, "Replace Filter" will blink seven times and an alert tone will sound three times. ■ RESET the water filter status tracking feature. After you replace the disposable filter with a new filter, closing the filter compartment door will automatically reset the filter status tracking feature. See "Using the Control(s)." NOTE: "REPLACE FILTER" will remain illuminated if a filter is not installed or is installed incorrectly. Replace the Water Filter To purchase a replacement water filter, see "Accessories" in the User Guide, Use and Care Guide or User Instructions. Replace the disposable water filter when indicated on the water filter status display or at least every 6 months. If water flow to your dispenser or ice maker decreases noticeably, change the water filter sooner. 1. Locate the water filter compartment in the right-hand side of the refrigerator ceiling. Push up to release and lower the compartment door. 2. Turn the water filter counterclockwise (to the left), and pull it straight out of the compartment. NOTE: There may be some water in the filter. Some spilling may occur. Use a towel to wipe up any spills. 3. Install the replacement water filter by following steps 2 through 7 in the "Install the Water Filter" section. Install Air Filter (on some models) An air filter is 15 times more powerful than baking soda at reducing common food odors inside the refrigerator. On some models, your refrigerator's accessory packet includes an air filter, which must be installed prior to use. Installing the Filter Status Indicator The filter comes with a status indicator, which should be activated and installed at the same time the air filter is installed. REPLACE MONTHS 1. Place the indicator face-down on a firm, flat surface. 2. Apply pressure to the bubble on the back of the indicator until the bubble pops to activate the indicator. 3. Lift open the vented air filter door. On some models, there are notches behind the door. Models with notches: ■ With the indicator screen facing outward, slide the indicator down into the notches. NOTE: The indicator will not easily slide into the notches if the bubble has not been popped. ■ Close the air filter door, and check that the indicator is visible through the window in the door. A B C A. Status indicator window B. Air filter status indicator C. Notches Models without notches: ■ Place the indicator somewhere it is easily visible either inside the refrigerator, or elsewhere in your kitchen or home. Installing the Air Filter Install the air filter behind the vented door, located on the rear wall near the top of the refrigerator compartment. 1. Remove the air filter from its packaging. 2. Lift open the vented door. 3. Snap the filter into place. Replacing the Air Filter The disposable air filter should be replaced every 6 months, when the status indicator has completely changed from white to red. To order a replacement air filter, contact us. See "Accessories" in the User Guide, Use and Care Guide or User Instructions for information on ordering. 1. Remove the used air filter by squeezing in on the side tabs. 2. Remove the used status indicator. 3. Install the new air filter and filter status indicator using the instructions in the previous sections. A A. Air filter 13