Whirlpool WTW4955H Owners Manual - Page 15
knob to Deep Water Wash setting. See Cycle Guide to match
View all Whirlpool WTW4955H manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
Troubleshooting First try the solutions suggested here or visit our website at www.whirlpool.com/owners (in Canada www.whirlpool.ca/owners) for assistance and to possibly avoid a service call. If you experience Possible Causes Solution Washer not performing as expected (cont.) Washer won't run or fill, washer stops working, or wash light remains on (indicating that the washer was unable to fill appropriately) (cont.) Normal washer operation. Washer may be tightly packed. Lid must be closed for washer to run. Washer will pause during certain phases of cycle. Do not interrupt cycle. Remove several items, rearrange load evenly in basket, and add detergent. Close lid and press START/PAUSE/CANCEL. Do not add more than one or two additional items after cycle has started to avoid tightly packing or unbalancing. Washer not draining/ spinning, loads are still wet, or final spin light remains on (indicating that the washer was unable to pump out water within 10 minutes) Small items may have been caught in pump or between basket and tub, which can slow draining. Using a cycle with a low spin speed. Empty pockets and use garment bags for small items. Cycles with lower spin speeds remove less water than cycles with high spin speeds. Use the recommended cycle/spin speed for your garment. To remove extra water in the load, select Drain & Spin. Load may need to be rearranged to allow even distribution of the load in the basket. The washer may be tightly packed or unbalanced. Tightly packed or unbalanced loads may not allow the washer to spin correctly, leaving the load wetter than normal. Evenly arrange the wet load for balanced spinning. Select the Drain & Spin cycle to remove excess water. See "Using Your Washer" for loading recommendations. Check plumbing for correct drain hose installation. Drain hose extends into standpipe further than 4.5" (114 mm). Check drain hose for proper installation. Use drain hose form and securely attach to drain pipe or tub. Do not tape over drain opening. Lower drain hose if the end is higher than 96" (2.4 m) above the floor. Remove any clogs from drain hose. Too much detergent causing suds Always measure and follow detergent directions for your load. to slow or stop draining and spinning. To remove extra suds, select Rinse & Spin. Do not add detergent. Dry spots on load after cycle High speed spins extract more moisture than traditional top-load washers. The high spin speeds combined with air flow during the final spin can cause items near the top of the load to develop dry spots during the final spin. This is normal. Washer may be tightly packed. Use Bulky/Sheets cycle for higher water fill, or set Water Level knob to Deep Water Wash setting. See "Cycle Guide" to match your load with the best cycle. Added extra garments to the load after the sensing/fill phase. Add only one or two additional garments after washer has started. Incorrect or wrong wash or rinse temperatures Check for proper water supply. Make sure hot and cold inlet hoses are not reversed. Both hoses must be attached to both washer and faucet and have both hot and cold water flowing to inlet valve. Check that inlet valve screens are not clogged. Remove any kinks in hoses. Energy saving controlled wash temperatures. This washer uses cooler wash and rinse water temperatures than your previous washer. This includes cooler hot and warm washes. Load not rinsed Check for proper water supply. Make sure hot and cold inlet hoses are not reversed. Both hoses must be attached and have water flowing to the inlet valve. Both hot and cold water faucets must be on. Inlet valve screens on washer may be clogged. Remove any kinks in the inlet hose. Not using HE detergent or using too much HE detergent. The suds from too much detergent can keep washer from operating correctly. Always measure detergent and follow detergent directions based on load size and soil level. Washer not loaded as recommended. The washer is less efficient at rinsing when load is tightly packed. Load garments in loose heaps evenly around the basket wall. Load with dry items only. 15