Whirlpool WUB50X24HZ Owners Manual - Page 7
Using the Control, Beverage/Wine Racks
View all Whirlpool WUB50X24HZ manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
Using the Control For your convenience, your beverage center control is preset at the factory. When you first install your beverage center, make sure that the control is still preset to the mid-setting as shown. Adjusting Controls The mid-setting indicated in the previous section should be correct for normal usage. The control is set correctly when beverages are as cold as you like. If you need to adjust the temperature, wait at least 24 hours between adjustments and then recheck the temperature. To make the beverage center colder, adjust the control to the next higher setting. To make the beverage center less cold, adjust the control to the next lower setting. Temperature Separator (Temperature Display) The temperature separator displays the current temperatures (Fahrenheit or Celsius) for the upper and lower zones (compartments) of the beverage center. To adjust the temperature settings, see "Adjusting Controls" earlier in this section. A B A. Dimmer B. Upper zone display C D C. Lower zone display D. Fahrenheit/Celsius Beverage/Wine Racks Upper Wine Rack To remove the wine rack: 1. Remove all bottles from the wine rack. 2. Lift the wine rack straight up slowly until it clears all four resting posts. Pull the rack out of the compartment. To replace the wine rack: IMPORTANT: The wine rack hooks should be facing down when the wine rack is installed. 1. Place the wine rack into the compartment above the four resting posts and slide the rack back until it is aligned with all four resting posts. 2. Push down gently on the rack until the wine rack hooks snap firmly onto the two rear posts and the front of the rack is resting on the two front posts. Lower Wine Rack To remove the wine rack: 1. Remove all bottles from the wine rack. 2. Slowly, lift the wine rack straight up slowly until it clears all four resting posts. Pull the rack out of the compartment. To replace the wine rack: IMPORTANT: The wine rack hooks should be facing down when the wine rack is installed. 1. Slide the wine rack into the compartment until the two hooks on the back of the rack are aligned with the two rear resting posts. 2. Push down gently on the rack until the hooks on the back of the rack snap firmly onto the two rear posts. Rest the front of the rack on the compartment floor. Side View C A D B A. Upper wine rack B. Lower wine rack C. Rack hook D. Resting post 7