Whirlpool WUW35X24DS Use & Care Guide - Page 7
Warning
View all Whirlpool WUW35X24DS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
12. Put decal at the top of wine cellar. Place decal here Decal Place decal 13. After you change door (left hinge), place Whirlpool badge at bottom of wine cellar. (Only models: WUW55X15DS & WUW55X24DS) NOTE: The decal & Whirlpool badge are included in the bag with Use and Care Guide. 4. Remove the base grille. To Replace the Base Grille: 1. Open the wine cellar door. 2. Reattach the mechanical switch using the two sensor screws. 3. Replace the two base grill screws. Tighten the screws. Handle Assembly NOTE: Only for models WUW55X15DS & WUW55X24DS. WARNING Excessive Weight Hazard Use two or more people to move and install wine cellar. Failure to do so can result in back or other injury. Helpful Tip: Put cardboard under wine cellar until it is installed in cabinet opening. The cardboard will help avoid damage to floor covering during installation. NOTES: To ease installation, using two or more people, place wine cellar on its back. To avoid scratching the front panel, place a soft cloth or towel against the panel while installing the door handle. Setscrews are preinstalled in the handle. 1. Remove the door handle and hardware bag containing the hex key from the bubble pouch. 2. Place the handle on the mounting studs. The setscrews should face down when installed correctly. If the handle is installed upside down, proper installation will not be possible. 3. Push the door handle tightly against the door. 4. Insert the short end of the hex key into the setscrew and tighten ¹⁄₄ turn past snug. Setscrew will not be recessed into the handle. 5. Repeat Step 4 for other setscrew. 6. Keep the hex key with the Installation Instructions NOTE: The handle installation procedure should take less than 5 minutes. 14. Check the alignment of the door and the door seals. 15. Tighten the hinge screws (as necessary). Base Grille You must remove the base grille to access the condenser coils for cleaning. To Remove the Base Grille: 1. Open the wine cellar door. 2. Using a Phillips screwdriver, remove the two screws from the base grille. 3. Remove the two screws holding the mechanical switch to the grille. D A C B A. Mounting stud B. Door handle C. Setscrew D. Hex key 7