Whirlpool WVU37UC4F Installation Instructions - Page 12
Install Range Hood
View all Whirlpool WVU37UC4F manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
Install Range Hood 1. Remove the power supply knockout from the top or rear of the vent hood (depending on the incoming location of your home power supply cable) and install a UL Listed or CSA Approved ¹⁄2" strain relief. A 4. With the aid of a 4.5 x 13 mm screw, mount 2 brackets on the inside front or side face of the cabinet, flush with the cabinet bottom. A. Power supply knockout 2. Align the exterior edge of the mounting brackets with the exterior edges of the upper cabinet. IMPORTANT: The brackets should touch the upper cabinet. With a pencil, mark the upper holes on the brackets. 5. Lift the range hood into place, positioning the rear slots over the mounting brackets. 6. Mount a round washer and a 4.5 x 13 mm screw to install the mounting brackets on the front of the cabinet. A. Cabinet front face edge B. Rear installation bracket marks 3. Using a #2 Phillips screwdriver, install the drywall anchors. Using #8-18 x 1" (4.2 x 25 mm) flat-head #2 Phillips screws, install the mounting brackets using the upper holes. NOTE: For installation to a surface other than drywall, it is recommended that a qualified contractor determine the anchoring method. B A A. #8-18 x 5/8" (4.2 x 16 mm) screw B. Washer 7. (Optional) Insert a #8-18 x 5⁄8" (4.2 x 16 mm) screw into the mounting tab (A) on each side of the range hood shown in the following image. A A. #8-18 x 5/8" (4.2 x 16 mm) screw 12