Whirlpool WVU7130JS Owners Manual - Page 12
Range Hood Use, Range Hood Care
View all Whirlpool WVU7130JS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
RANGE HOOD USE The range hood is designed to remove smoke, cooking vapors and odors from the cooktop area. For best results, start the hood before cooking and allow it to operate several minutes after the cooking is complete to clear all smoke and odors from the kitchen. The hood controls are located on the front panel on the right side of the range hood. A C Liquid detergent or all-purpose cleaner: Rinse with clean water and dry with soft, lint-free cloth. Metal Grease Filter 1. A D B A. LED lamps B. Grease filter handle C. Blower and light controls D. Grease filter Range Hood Controls A B C D A. On/Off light button B. Blower Off and speed minimum button C. Blower speed medium button D. Blower speed maximum button Operating the light The On/Off light button controls the light. Press once for On and again for Off. Operating the blower The BLOWER SPEED buttons turn the blower on and control the blower speed and sound level for quiet operation. The speed can be changed anytime during fan operation by pressing the desired blower speed button. Press the BLOWER OFF button a second time to turn the blower off. 2. solution. 3. A. Spring release handle 4. Push in spring release handle. 5. 6. Replacing LED Lamps To avoid damage or decreasing the life of the new lamp, do not wearing cotton gloves to handle lamp. If new lamps do not operate, make sure the lamps are inserted correctly before calling service. 1. Disconnect power. 2. Push up on the lens and turn it counterclockwise. RANGE HOOD CARE IMPORTANT: Cleaning before operating the hood. Exterior Surfaces IMPORTANT: cleaners, Cooktop Polishing Creme, steel wool, gritty washcloths or paper towels. Cleaning Method: Rub in the direction of the grain to avoid scratching or damaging the surface. Stainless Steel Cleaner and Polish (not included). See "Assistance or Service" section to order. 3. Remove and replace it with an appropriate Energy Star GU10 base. Turn it clockwise to lock it into place. 4. Repeat steps 2-3 for the other lamps if needed. 5. Reconnect power. 12