Xerox 6180N DocuTech 61xx - Operator HandyBook - Page 24

Paper Trays & Loading Media Satisfaction Guide for 2-Sided Printing Stock Size Weight Type or condition Reliable feeds may be expected 8 x 10 inches to 17 x 11 inches (203 x 254 mm to 432 x 279 mm) Substance 16 to 110 (60 to 200 g/m2) Substance 110 (200 g/m2) must be long grain. Xerographic bond paper in good condition Drilled stock, fanned thoroughly Less reliable feeds may be expected Slightly curled paper Paper with reinforced edges Suggested alternatives 17 x 11 inch (432 x 279 mm) paper can only be sent to the top tray. Weights outside the limits shown are not recommended. Do not use excessively curled paper Refer to the "Using various stocks" section for any stock not defined in this guide. Satisfaction Guide for Various Stocks Stock type • Recycled Paper • Substance 13 (49 g/m2) paper • Substance 16 (60 g/m2) paper • Substance 20 (75 g/m2) paper • Card stock • Xerox substance 65 (176 g/m2) • Substance 110 (200 g/m2) long grain (index) • Xerox 4024, substance 20 (75 g/m2) • 3 hole drilled • 4 hole drilled • 7 hole drilled • Never-tear, 3 hole drilled DT6180 HandyBook Instructions for use Acceptable, but may increase paper dust contamination problems in machine. Recommend vacuum paper before installing in machine to minimize paper dust. Use trays 3,4,or 5. Do not run 2-sided prints. Load the paper with seam side down into tray 3. Optimum satisfaction can be expected with 8.5 x 11 inch (216 x 279 mm) or larger paper. Load paper with seam side up into trays 1 and 2; seam side down into tray 3, 4, or 5. Optimum satisfaction can be expected from tray 3, 4, or 5. Load the paper with seam side up into trays 1 and 2; seam side down into trays 3, 4, and 5. Card stock can be run from any tray. Reduce set size if frequent paper jams or bindexer jams occur. If collated unfinished, another solution is to lower the value of the bindexer capacity set in the SWITCHES mode. Load the paper into trays 1 and 2 with holes to the right; load the paper into trays 3, 4, and 5 with holes to the left. Use the Image Shift or Reduce/Enlarge options to avoid printing near the holes. Fan the paper and check the paper for loose paper plugs before loading the paper into the trays. Load the paper into trays 1 and 2 with holes to the right; load the paper into trays 3, 4, and 5 with 24