Xerox 750DX Fiery SI v1.2 Expectation Setting Document - Page 5

Expectation Setting Document for the Fiery Si v1.2 SEPARATIONS SUPPORT • The Fiery Si does not support Trapping and Overprinting commands. STARR compression cannot support the "combine separations" feature needed to print trapping and overprinting successfully. CUSTOMER SUPPORT • The Xerox Customer Support Centers are available for general information, questions, or placing service calls: USCO 1-800-821-2797 XCI 1-800-939-3769 • Your Xerox Color Analyst will provide fee-based training upon request. SPACE REQUIREMENTS • Refer to the specific Xerox Digital Color Copier Customer Expectation Setting Guide for reference. • The Fiery Si should be positioned such that there is 24 inches (610mm) of unobstructed work area on each side of the placement. • For the DocuColor 5750, the right side measurement is 55" and the left side measurement is 17". • At no time should any overhead obstruction be closer than 6 feet (1828.8mm) over the location of the Fiery Si. • The maximum distance between the Fiery Si and the Xerox Digital Color Copier is limited by the original length of the interface cable. REFERENCE MATERIAL • The following documentation is available on theCustomer CD in Acrobat PDF format for more detailed information on this product: -Quick Start Guide -Administrator Guide -User's Guide -Operator Guide -Customer Release Notes (hardcopy only) POWER REQUIREMENTS • Voltage ranges are from 100-120 VAC and 200-240 VAC. • The power supply inside the Fiery Si automatically configures to either 120 VAC at 60 Hz or 240 VAC at 50 HZ. • The Fiery Si requires the use of two outlets: one for the Fiery Si and one for the CD ROM. Fiery Si v1.2 MajestiK/ Regal/ Empress/ Countess Terms and product names used in this document may be trademarks or registered trademarks of their respective companies and are hereby acknowledged. Launch Version 9/16/97