Xerox 790N Fiery SI Color Server User Guide - Page 87
After the yellow strip is measured, Pass #3 of 4 OK! appears in the densitometer
![]() |
UPC - 042215474368
View all Xerox 790N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 87 highlights
66-9 Understanding calibration 2. With the arrow below the cyan column pointing towards the densitometer, align the right side of the patches page with the strip guide. 3. Insert the patches page into the densitometer until it rests against the drive rollers and the motor is activated. There may be a slight hesitation before the rollers start. 4. Hold the page against the guide to prevent any skewing while the strip is being measured. After the strip is measured, Pass #1 of 4 OK! appears in the densitometer display. Transmitting Data appears briefly after each pass. 5. When prompted, move the strip guide to 30 and measure the magenta column. After the magenta strip is measured, Pass #2 of 4 OK! appears in the densitometer display. 6. Turn the patches page around so that the arrow above the yellow column is pointing toward the densitometer. Leave the strip guide set to 30. 7. When prompted, align the right side of the patches page with the strip guide and measure the yellow column. After the yellow strip is measured, Pass #3 of 4 OK! appears in the densitometer display. 8. When prompted, move the page guide to 15 and measure the black column. After the black strip is measured, Pass #4 of 4 OK! appears in the densitometer display. NOTE: If there is a problem measuring a color, follow the instructions on the densitometer to remeasure it.
![](/manual_guide/products/xerox-750dp-fiery-si-color-server-user-guide-445a156/87.png)