Xerox 91909704 User Guide - Page 39
Engaging Paper Out Override can cause loss of data and, damage the printhead by allowing printing
UPC - 051851440590
View all Xerox 91909704 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 39 highlights
Page Width, Default = Depends on Feed Path Wide carriage model only. For rear and bottom paths, the default is 13.6". Change to 8" if you will be printing on narrow paper. This prevents printing on the platen which can damage the printhead and the platen, and can cause loss of data. For the top feed path the default is 8". Change to 13.6" to print on wide paper. Paper Out Override, Default = No Senses when less than 1" (25 mm) of paper remains and stops printing. Change to Yes to override the sensor and print closer to the bottom of the page. Caution!! Engaging Paper Out Override can cause loss of data and damage the printhead by allowing printing without paper. Parity, Default = None Appears only when the optional Serial Interface is installed. Selects the type of parity your system uses: None, Odd or Even. Pin 18, Default = +5V Sets the signal on pin 18 to +5 volts or open. Pitch, Default = 10 cpi Choose the character width, in characters per inch (cpi). Power Save Time, Default = 5 min Sets the interval the printer waits for more data before it goes into the power save mode. Power Saving must be set to Enable (the factory default) for this to be effective. Power Saving, Default = Enable Change to Disable if you wish to prevent the printer from entering the Power Save mode after the selected interval. Mode Menu 39