Yamaha 02C Bench For Els-02/els-02c Owner's Manual - Page 2

Post-assembly checklist After completing the assembly, please check the following. • Are all of the bolts and screws properly tightened?  Make sure to properly tighten all bolts and screws. • Is the bench stable?  If the bench is unstable, adjust the bench legs, referring to the instructions in the next section, "If the bench is unstable." • Are the legs attached correctly (left and right)? R L If the bench is unstable If the bench is unstable, adjust it in the following manner. 1 With the legs on the floor in the normal position, temporarily loosen the bolts indicated with a mark written on them. 2 Tighten the bolts that attach the legs using the included wrench. Make sure to properly tighten all bolts so that there is no gap between the bolts and the washers. Logo is written on back Bolt Washer 3 Return the bench to the original position, and check that the bench is stable. If the bench is in any way unstable, adjust it in steps 1 and 2 again. If this does not solve the problem, contact your Yamaha dealer. If the bench bolts/screws become loose due to extensive long-term use, tighten them periodically using the included tool and a screwdriver. - 2 - EN C.S.G., DMI Development Division © 2014 Yamaha Corporation Published 04/2014 MW-01B0 ZJ88110