Yamaha 565 RX-V465/565/665 FIRMWARE UPDATE VERSION K032 USA Model - Page 3
M:K032, Congratulations
View all Yamaha 565 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 3 highlights
Firmware Update Procedure for RX-V465/565/665/765 STEP3 Plug the AC power cable of the CD/DVD player to the wall outlet. Insert the Firmware Update CD (Audio CD) into the CD/DVD player and close the tray. If the disc begins to play automatically, press STOP button on the CD/DVD player. STEP4 ENTER FIRMWARE UPDATE MODE While pressing the "STRAIGHT" key on the front panel of the AV receiver, connect the power cable of this unit to the AC outlet. The firmware update mode is activated and "CDDA UPGRADER" is displayed. STEP5 START FIRMWARE UPDATE Press the "PLAY" key of the CD/DVD player. Then, writing of the firmware is started. "Found Header" will appear for few seconds. While update is in progress, DO NOT interrupt the AV receiver by pressing the buttons or switching off the power. If an unintended failure occurs, you may start the update process again from the beginning. Or see IN CASE OF ERROR on the last page to recover. STEP6 When writing of the firmware is completed, "Update Success", "Please..." and "Power off!!" are displayed repeatedly. STEP7 Stop the DVD/CD player, remove update disc and power off. STEP8 Turn off the power of AV receiver. STEP9 CHECK UPDATED VERSION Press and hold the [STRAIGHT] button on the front panel and keep it pressed while you press the [STANDBY/ON] button. Once the front panel displays "Advance Setup", release the [STRAIGHT] button. Then, press and hold the [TONE CONTROL] button for about 3 seconds until front panel displays "M:K032 8FFD". K032: version of firmware 8FFD: checksum If your firmware version number and checksum don't match, retry from step 2. Or try the IN CASE OF ERROR method on the last page. STEP10 Turn off the power of AV receiver. Congratulations! You have completed the firmware update. Your AV receiver is ready for normal use. Page.3 of 4