Yamaha 93 YAS-103/93 Owners Manual - Page 16

Sending the TV's remote signal through the sound bar (TV Remote Repeater function) When the TV Remote Repeater function is enabled, the sound bar relays the TV's remote signal received by the front sensor to the rear transmitter. This function should be enabled when you place the sound bar in front of your TV and you cannot operate your TV with the TV's remote control. NOTE • This function is available only when your TV's remote control uses infrared signals. IR flasher for TV Remote Repeater TV's remote control sensor TV's remote control 1 Turn on the sound bar. 2 Hold down the REPEATER key on the sound bar's remote control for more than 3 seconds to enable/disable the TV Remote Repeater function. Flash 3 times (enabled), flash once (disabled) This completes the necessary settings. When the TV Remote Repeater function is enabled, you can operate your TV from the TV's remote control via the sound bar. HINT • The TV Remote Repeater function is disabled by default. • If the power cable of the sound bar is connected to an AC wall outlet and when the TV Remote Repeater function is enabled, the function is usable even when the sound bar is turned off. • If you have made the sound bar learn the volume (+) operation (p.13), the volume of the TV may be turned up when you turn up the volume of the sound bar with the TV's remote control. In this case, follow Step 3 in "Connections" (p.6) to change the TV setting. • You can check the status of the TV Remote Repeater function by the center indicator when turning on the sound bar. Off (enabled), lights up (disabled) Setting the auto power standby function By enabling the auto power standby function, you can avoid forgetting to turn off the sound bar after use, or if you fall asleep while watching TV. NOTE • When the auto power standby function is enabled and one of the following conditions is met, the sound bar will automatically turn off. − No operations for 8 hours − No audio input and no operations for 20 minutes when BLUETOOTH is selected as the input source. 1 With the sound bar turned off, hold down the MUTE key on the sound bar's remote control for more than 3 seconds. You can check the status of the auto power standby function when turning on the sound bar. Off (enabled), lights up (disabled) HINT • Initial setting varies depending on the country or region. − U.K. and Europe models: enabled − Other models: disabled Initializing the sound bar Follow the procedure below to initialize the sound bar. 1 Turn off the sound bar. 2 Hold down (power) on the front panel of the sound bar for more than 3 seconds. Flash (initialized) 14 En