Yamaha A4000 Owner's Manual - Page 244
Installing an Internal IDE Hard Disk
View all Yamaha A4000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 244 highlights
Installing Optional Equipment Installing an Internal IDE Hard Disk This section explains how to install a standard IDE hard disk drive (bare drive) into the A5000/A4000. IDE hard disk cable (40-pin): Supplied Hard disk power cable (long): Supplied IDE hard disk: Optional Hard disk installation screws (4 pcs.): Optional Important • Before performing the installation, please read precautions "Handling and Installation of Options," found at the beginning of this manual. • Consult your Yamaha dealer for information about IDE hard disk models that have been confirmed as operating correctly with the A5000/A4000. [Procedure] 1. Be sure that you have the following at hand before starting the installation. • Internal IDE hard disk • Hard disk installation screws (4 pcs.): Available from your hard disk dealer. • IDE hard disk cable (40-pin): supplied with the A5000/A4000. • Hard disk power cable (long red-and-white 4-wire cable): supplied with the A5000/A4000. • Phillips screwdriver: Magnetic-tipped screwdriver is recommended. • Screwdriver for the hard-disk installation screws: Note that some hard-disk models do not use Phil- lips-head screws. • Workbench: Please carry out all work on a stable workbench or table. Spreading a cloth over the work surface will help prevent scratching. • Gloves: Be sure to wear gloves so that your hands are not scratched by the metal cover or other metal parts. 2. Check the hard disk settings. • When using an IDE hard disk alone (i.e. when no ZIP drive is installed), the IDE hard disk must be set to "MASTER" (for information on MASTER/SLAVE settings, see the disk's owner's manual/specification sheet). • When using an IDE hard disk in conjunction with a ZIP drive, one drive must be set to "MASTER" and the other to "SLAVE" (for information on MASTER/SLAVE settings, see the disk's owner's manual/ specification sheet). 3. Remove the top cover (page 232). 4. Remove the four gold-colored screws holding the hard disk mount panel, and remove the mount panel from the A5000/A4000. Refer to page 240 for "Installing an Internal SCSI Hard Disk." 244 Appendix • A5000/A4000 q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q q