Yamaha AG06 Technical Specifications - Page 1
Yamaha AG06 Manual
![]() |
View all Yamaha AG06 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1 highlights
MIXING CONSOLE Technical Specifications ZN24170 General Specifications 0 dBu = 0.775 Vrms, Output impedance of signal generator (Rs) = 150 Ω All level controls are nominal if not specified. Frequency Response Input (MIC) to MONITOR OUT via USB IN/OUT Total Harmonic Distortion *1 (THD+N) Hum&Noise *2 (20 Hz to 20 kHz) Crosstalk (1 kHz) *3 Input to MONITOR OUT Equivalent Input Noise Residual Output Noise Input Channels Output Channels Bus PAD Input Channel Function (CH1, CH2) DSP Level Meter USB Audio Phantom Power Voltage FOOT SW Power Requirements Power Consumption Dimensions (WxHxD) Net Weight PEAK LED USB Output Level 2 IN / 2 OUT Included Accessory Optional Accessory Operating Temperature *1 THD+N is measured with 22 kHz LPF. *2 Noise is measured with A-weighting filter. *3 Crosstalk is measured with 1 kHz band pass filter. +0.5 dB/-1.5 dB (20 Hz to 48 kHz @ Fs = 192 kHz), refer to the nominal output level @ 1 kHz, GAIN knob: Min, TO PC: DRY CH1-2 0.05% @ 0 dBu (20 Hz to 20 kHz), GAIN knob: Min 0.01% @ +4 dBu (1 kHz), GAIN knob: Min -128 dBu (Mono Input Channel, Rs: 150 Ω, GAIN knob: Max) -103 dBu (MONITOR OUT, MONITOR knob: Min) -80 dB Mono (MIC/LINE): 2 including HEADSET MIC (Plug-in Power) (CH1 MIC and HEADSET MIC cannot be used simultaneously.), Stereo (LINE): 2, USB IN: 1, AUX IN: 1 STEREO OUT: 1, MONITOR OUT: 1, PHONES: 2 including HEADSET PHONES (PHONES and HEADSET PHONES cannot be used simultaneously.) Stereo: 1 26 dB CH1: COMP/EQ, EFFECT (SPX Reverb) CH2: AMP SIM, EFFECT (SPX Reverb) LED turns on when the signal reaches 3 dB below clipping level. 2x2 point LED meter [PEAK, SIG] USB Audio Class 2.0 compliant, Sampling Frequency: Max 192 kHz, Bit Depth: 24-bit +48 V EFFECT Mute on/off DC 5 V, 500 mA Max. 2.5 W 155 mm x 63 mm x 202 mm (6.1" x 2.5" x 8.0") 1.0 kg (2.2 lbs) USB Cable (1.5 m), CUBASE AI DOWNLOAD INFORMATION, Owner's Manual, Technical Specifications (this leaflet) Foot Switch: FC5, Mic Stand Adaptor: BMS-10A 0 to +40°C The contents of this manual apply to the latest specifications as of the printing date. Since Yamaha makes continuous improvements to the product, this manual may not apply to the specifications of your particular product. To obtain the latest manual, access the Yamaha website then download the manual file. Since specifications, equipment or separately sold accessories may not be the same in every locale, please check with your Yamaha dealer. Analog Input Characteristics 0 dBu = 0.775 Vrms Input Jack PAD 26 dB GAIN Trim/SW Position Actual Load Impedance For Use with Nominal Sensitivity *1 Input Level Nominal Max. Before Clip Connector OFF MIC/LINE 1 - 2 HEADSET MIC ON 10 -72 dBu (0.195 mV) -60 dBu (0.775 mV) -50 dBu (2.451 mV) Combo jack *2 0 10 3 kΩ 1.5 kΩ *4 50-600 Ω Mics/Lines -26 dBu (38.84 mV) -46 dBu (3.884 mV) -14 dBu (154.6 mV) -34 dBu (15.46 mV) -4 dBu (489.0 mV) -24 dBu (48.90 mV) (Balanced) 3.5 mm Phone jack For CH1 HEADSET MIC (Plug-in Power/ Unbalanced) 0 0 dBu (775.0 mV) +12 dBu (3.085 V) +22 dBu (9.757 V) 10 OFF 0 INPUT CH2 GUITAR *5 10 ON 0 1 MΩ -68 dBu (3.085 mV) -56 dBu (1.228 mV) -46 dBu (3.884 mV) -22 dBu -10 dBu 0 dBu - (61.56 mV) -42 dBu (245.1 mV) -30 dBu (775.0 mV) -20 dBu Phone jack *3 (Unbalanced) (6.153 mV) (24.51 mV) (77.5 mV) +4 dBu (1.228 V) - +10 dBu (2.451 V) LINE 3/4, 5/6 HIGH -20 dBu (77.5 mV) -8 dBu (308.5 mV) +2 dBu (975.7 mV) - 10 kΩ 600 Ω Lines LOW -10 dBu (245.1 mV) +2 dBu (975.7 mV) +12 dBu (3.085 V) AUX - - 10 kΩ 600 Ω Lines -14 dBu (154.6 mV) -8 dBu (308.5 mV) +2 dBu (975.7 mV) *1 Sensitivity is the lowest level that will produce an output of +0 dBu (0.775 V) or the nominal output level when the unit is set to maximum gain. (All level controls are at their maximum position.) *2 1&Sleeve = GND, 2&Tip = HOT, 3&Ring = COLD *3 Tip = Signal, Sleeve = GND *4 For CH1, HEADSET MIC *5 For CH2, GUITAR switch is ON LINE 3/4 Phone jack *3 (Unbalanced) LINE 5/6 RCA pin (Unbalanced) Stereo mini jack Analog Output Characteristics 0 dBu = 0.775 Vrms Output Terminal Actual Source Impedance For Use with Nominal STEREO OUT [L, R] 150 Ω 10 kΩ Lines MONITOR OUT [L, R] 150 Ω 10 kΩ Lines PHONES 120 Ω *6 Tip = HOT, Ring = COLD, Sleeve = GND 40 Ω Phones Output Level Nominal Max. Before Clip 0 dBu (0.775 V) +10 dBu (2.451 V) 0 dBu (0.775 V) +10 dBu (2.451 V) 1.5 mW + 1.5 mW 6 mW + 6 mW Connector Phone jack *6 (Impedance Balanced) Phone jack *6 (Impedance Balanced) Stereo phone jack Stereo mini jack Digital Input / Output Characteristics Terminal USB Format USB Audio Class 2.0/ Yamaha Steinberg USB Driver Data Length Sampling Frequency Connector 24-bit 44.1 kHz, 48 kHz, 88.2 kHz, 96 kHz, 176.4 kHz, 192 kHz USB Standard-B
![](/manual_guide/products/yamaha-ag06-technical-specifications-84a9529/1.png)