Yamaha AG06MK2 AG06MK2 AG03MK2 Safety Guide - Page 4
Precautions for use, NOTICE
View all Yamaha AG06MK2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
Precautions for use Handling • Do not drop a foreign object, such as a piece of metal or paper, into any gap on this product. Otherwise, fire, electrical shock or damage to the product may be caused. • Do not apply the following excessive force to this product. - Resting your weight on this product - Placing heavy objects on this product - Stacking up this product - Applying excessive force to the buttons, switches, or I/O connectors Otherwise, injury or damage to the product may be caused. • Do not pull connected cables. Otherwise, the product may fall or tip over, resulting in injuries or damage to the product. Precautions for use NOTICE Follow the precautions below to avoid malfunction and damage to this product and to prevent the loss of data. Power supply • If you plan not to use this product for a long period of time, disconnect the USB cable from this product. Even when the [P] (Standby/On) switch is turned off, a small amount of current still flows through this product. • Never insert or remove a USB cable with wet hands. Installation • Depending on the environment in which you use the product, a phone, radio or TV may generate noise. In that case, change the product location or orientation, or the surrounding environment. • Do not install this product in a place subject to: - Extremely high or low temperatures - Excessive dust Otherwise, malfunction or damage to the product may be caused. • Do not install this product in a place where condensation can form due to rapid, drastic changes in ambient temperature. Using the product while condensation is present may cause damage to the product. If there is a reason to believe that condensation might have occurred on or in this product, leave it for several hours without turning on the power. You can start using the product when the condensation has completely dried. Handling • Do not place any vinyl, plastic or rubber products on this product. Otherwise, the panel may be discolored or deteriorate. • Avoid setting all equalizer controls and volume to their maximum. Depending on the condition of the connected devices, doing so may cause feedback and may damage the speakers. • Do not apply oil, grease, or contact cleaner to the faders or knobs. Doing so might cause problems with electrical contact or fader and knobs motion. Maintenance • Use a dry, soft cloth to clean this product. Do not use benzine, thinner, detergent or chemical rag to clean the surface of the product. Otherwise, the surface may be discolored or deteriorate. [USB 2.0] and [5V DC] terminals When connecting the computer to the [USB 2.0] connector, make sure to observe the following points. Failing to do so risks freezing the computer and corrupting or losing the data. If the computer or the mixer freezes, restart the application software or the computer OS, or turn the mixer's [P] (Standby/On) switch to standby and then on again. • Be sure to use the included USB cable. • Before connecting the computer to the [USB 2.0] terminal, exit from any power-saving mode of the computer (such as suspend, sleep, standby). • Turn the [P] switch to standby before connecting cables to the [USB 2.0] and [5V DC] terminals. • Be sure to quit any open applications and turn the [P] switch to standby before unplugging cables from the [USB 2.0] and [5V DC] terminals. • Wait for six seconds or more whenever turning the mixer's [P] switch from standby to on or from on to standby. Connectors XLR-type connectors are wired as follows (IEC60268 standard): pin 1: ground, pin 2: hot (+), and pin 3: cold (-). Phantom Power Be sure to leave this switch off (N) if you do not need phantom power. Follow the important precautions below, in order to prevent noise and possible damage to external devices as well as the mixer if you turn this switch on (O). 4 AG06MK2/AG03MK2 Safety Guide EN