Yamaha AX 596 MCXSP10 Manual - Page 6

CAUTION: Read this before operating your unit. 1. To assure the finest performance, please read this manual carefully. Keep it in a safe place for future reference. 2. Install this unit in a cool, dry, clean place - away from windows, heat sources, sources of excessive vibration, dust, moisture and cold. Avoid sources of humming (transformers, motors). To prevent fire or electrical shock, do not expose the unit to rain or water. 3. Never open the cabinet. If something drops into the set, contact your dealer. 4. Do not use force on switches, controls or connection wires. When moving the unit, first disconnect the power plug and the wires connected to other equipments. Never pull the wires themselves. 5. The openings on the unit cover assure proper ventilation of the unit. If these openings are obstructed, the temperature inside the unit will rise rapidly; therefore, avoid placing objects against these openings. Install the unit in a well-ventilated area to prevent fire or damage. Be sure to allow a space of at least 20 cm behind, 20 cm on both sides and 30 cm above the top panel of the unit to prevent fire or damage. 6. The voltage used must be the same as that specified on this unit. Using this unit with a higher voltage than specified is dangerous and may result in fire or other accidents. YAMAHA will not be held responsible for any damage resulting from use of this unit with a voltage other than specified. 7. Always set the VOLUME control to "∞" before starting the audio source play. Increase the volume gradually to an appropriate level after the play has been started. 8. Do not attempt to clean the unit with chemical solvents as this might damage the finish. Use a clean, dry cloth. 9. Be sure to read the "TROUBLESHOOTING" section regarding common operating errors before concluding that the unit is faulty. 10. When not planning to use this unit for a long period (ie., vacation, etc.), disconnect the AC power plug from the wall outlet. 11. To prevent lightning damage, disconnect the AC power plug when there is an electric storm. 12. Grounding or polarization - Precautions should be taken so that the grounding or polarization of an appliance is not defeated. 13. Do not connect any audio equipment to the AC outlet on the rear panel if the equipment requires more power than the outlet is rated to provide. 14. VOLTAGE SELECTOR (China and General models only) The voltage selector on the rear panel of this unit must be set for your local main voltage BEFORE plugging into the AC main supply. Voltages are 110/120/220/240 V AC, 50/60 Hz. When this unit is turned off by pressing the STANDBY/ON switch on the front panel or the remote control, the STANDBY indicator on the front panel lights up. This state is called the standby mode. In this mode, this unit is designed to consume a small amount of power. This unit's power supply is completely cut off from the AC line only when the POWER switch on the front panel is set in the OFF position or the AC power cord is disconnected. For Canadian Customers To prevent electric shock, match wide blade of plug to wide slot and fully insert. This Class B digital apparatus complies with Canadian ICES-003. WARNING Do not change the IMPEDANCE SELECTOR switch setting while the power to this unit is on, otherwise this unit may be damaged. If this unit fails to turn on when the POWER switch is pressed: The IMPEDANCE SELECTOR switch may not be set to either end. If so, set the switch to either end when this unit's power supply is completely cut off. (U.S.A. model) R R L B SPEAKERS L A CAUTION SEE INSTRUCTION MANUAL FOR CORRECT SETTING. IMPEDANCE SELECTOR SET BEFORE POWER ON A OR B : 4ΩMIN. /SPEAKER A OR B : 6ΩMIN. /SPEAKER A B : 8ΩMIN. /SPEAKER A B : I2ΩMIN. /SPEAKER MAINS AC OUTLETS SWITCHED I20V 60Hz l00W MAX. TOTAL IMPEDANCE SELECTOR E-2