Yamaha C-5000 C-5000 Owner s Manual - Page 16

Remote control ᕡ ᕢ ᕣ ᕤ AMP OPEN/CLOSE CD 1 2 BAL BAL UNBAL PHONO 1 2 LINE CD EXT.DIRECT TUNER BAND ᕥ ᕦ PRESET SOURCE ᕧ LAYER VOLUME MUTE ᕨ ᕩ A. Infrared signal transmitter Outputs infrared control signals toward the unit. B. A AMP key Turns on the power to the unit or switches it to standby mode. For more information regarding standby mode, refer to "Front panel" (page 6). C. Input select keys Enable you to select the input source to be played back. BAL: Selects the component connected to the XLR-type BAL 1 or BAL 2 jacks as the input source. PHONO: Selects the turntable connected to the PHONO jacks (XLR-type or RCA) as the input source. Press the BAL key to select the source at the XLR-type jacks, or the UNBAL key to select the source at the RCA jacks. LINE: Selects the component connected to the RCA-type LINE 1 or LINE 2 jacks as the input source. EXT. DIRECT: Selects the component connected to the EXT. IN jacks as the input source. If EXT. DIRECT is selected as the input source, audio signals will not be output at the LINE 2 OUT or PHONES jacks. CD: Selects the component (usually, a CD player) connected to the RCA-type CD jacks as the input source. TUNER: Selects the component (usually, a tuner) connected to the RCA-type TUNER jacks as the input source. Note Audio signals of the selected input source will be output at the LINE 2 OUT (recording) jacks. If LINE 2 is selected as the input source, audio signals will not be output at the LINE 2 OUT (recording) jacks. D. Tuner control keys Enable you to control the functions of the connected Yamaha tuner. Use the BAND key to switch the reception band, and the PRESET er keys to select a preset station. For more information, refer to the owner's manual for your tuner. Note Some Yamaha tuner models might not support these key functions. 16