Yamaha CC-50 Owner's Manual - Page 29
Tape A or tape B playback, English, TAPE DECK OPERATION
![]() |
View all Yamaha CC-50 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 29 highlights
English TAPE DECK OPERATION 1 Receiver Tape Deck DECK A select button DECK B select button Tape A or tape B playback 1 Select the tape deck so that "TAPE" appears on the display by pressing the INPUT selector or button. 2 Open the DECK A or DECK B cassette compartment by pressing the EJECT button. 3 Load the tape into the DECK A or DECK B cassette compartment, and close the lid panel completely by pressing the upper part of the center of the panel as figured left. * If you loaded two tapes into both the DECK A and B cassette compartments, select the DECK A or B in which the tape to be played back is loaded by pressing the DECK A or B select button. 4 Set the Dolby NR switch to B or C if the tape has been recorded with Dolby noise reduction, and to OFF if Dolby NR was not used. * For selection of the Dolby B or C position, refer to the "Dolby B and C Type Noise Reduction" on page 29. 5 Set the reverse mode switch as desired. The reverse mode switch can be operated before or during playback, and changes tape playback as follows: 2 56 64 2 3 Side A only Side B only Side A → Side B Side A → Side B Continuous play (8 times) Side B only Side B → Side A Continuous play (8 times) 6 Press the play button to listen to side A, or the play button for side B. To stop playback Press the stop button. Note When removing the tape, press the stop then open the cassette compartment. button, and Direct operation Even if an input source other than tape deck is selected, pressing the play button (or the fast wind button) will start playback (or fast winding) directly. E-27
![](/manual_guide/products/yamaha-cc50-owners-manual-bc41ee1/29.png)