Yamaha CC-75 Owner's Manual - Page 11
Setting Up The System, Warning
![]() |
View all Yamaha CC-75 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
English PRECAUTIONS: READ THIS BEFORE OPERATING YOUR UNIT CAUTION FOR CARRYING THIS UNIT Be sure not to carry or tip this unit with discs remaining in it. CAUTION FOR MOVING THIS UNIT Before moving this unit, first remove all discs from the disc table and close the table by pressing the OPEN/CLOSE button, and then switch off the power by pressing the POWER switch, and last, after you confirm that "no disc" is illuminated on the display, disconnect the power plug from the AC outlet. The apparatus is not disconnected from the AC power source as long as it is connected to the wall outlet, even if the apparatus itself is turned off. VOLTAGE SELECTOR (General model only) The voltage selector on the rear panel of this unit must be set for your local main voltage BEFORE plugging into the AC main supply. Voltages are 110/120/220/240V AC, 50/60 Hz. WARNING To reduce the risk of fire or electric shock, do not expose this unit to rain or moisture. To avoid electrical shock, do not open the cabinet. Refer servicing to qualified personnel only. CAUTION 1 Use of controls or adjustments or performance of procedures other than those specified herein may result in hazardous radiation exposure. CAUTION 2 As the laser beam used in this unit is harmful to the eyes, do not attempt to disassemble the cabinet. Refer servicing to qualified personnel only. This unit is classified as a CLASS 1 LASER product. The CLASS 1 LASER PRODUCT label is located on the rear exterior. (Europe and U.K. model only) Laser component in this product is capable of emitting radiation exceeding the limit for Class 1. Laser Diode Properties Material: GaAlAs •• Wavelength: 780nm Emission Duration: continuous •• Laser Output: max. 44.6µW* * This output is the value measured at a distance of about 200mm from the objective lens surface on the Optical Pick-up Block. SETTING UP THE SYSTEM Setup examples KXW-S75 RX-S75 CDC-S75 10 cm 10 cm 1 cm 1 cm 10 cm 10 cm RX-S75 CDC-S75 KXW-S75 Place this system as illustrated on the left and allow spaces more than indicated around the system and more than 10 cm (3-15/16") behind the system to assure good ventilation. Be sure not to place another unit or any object on top of the receiver (RX-S75) to prevent the ventilation holes on the top panel of the receiver from being obstructed. Otherwise, it may cause fire or damage to the receiver. Notes • When placing the speakers apart from the main units, allow a space of at least 10 cm (3-15/16") from above, behind and on the both sides of the main units. • If the system is put in a rack, the front of it must be fully opened. • Disconnect the AC supply lead from the AC outlet before connecting or disconnecting any component. 10 cm 10 cm E-3
![](/manual_guide/products/yamaha-cc75-owners-manual-e5af1e8/11.png)