Yamaha CD-C603RK CD-C603RK Owners Manual - Page 26

Troubleshooting, front panel does not light up.

Get Yamaha CD-C603RK PDF manuals and user guides View all Yamaha CD-C603RK manuals
Add to My Manuals
Save this manual to your list of manuals

Page 26 highlights

Troubleshooting Refer to the table below if the unit fails to function properly. If the problem is not listed below, or if the symptoms persist after you follow the instructions below, turn off the power to the unit by pressing A (Power) on the front panel, disconnect the power cord, and contact your nearest authorized Yamaha dealer or service center. Problem Cause Solution Pressing A (Power) on the front panel does not turn the power on. The power cord may not be properly plugged in. Connect the power cord firmly to the AC outlet. The unit suddenly enters Standby mode. You did not interact with the unit for a certain amount of time after the playback stopped and the Auto Power Standby function has kicked in. Disable the Auto Power Standby function. The disc tray does not close completely. A foreign object is inside the disc tray enclosure. Check the disc tray and remove any foreign object. The disc is scratched. Change the disc. The lens inside the unit has condensation. Turn on the power to the unit, wait 20-30 minutes, and then try to play the disc again. Unable to play the inserted disc. Or, the corresponding slot indicator on the front panel does not light up. The disc is set upside down. The disc is dirty or scratched. You tried to play files in a format that is not supported by the unit. Be sure to place the disc with its label side up. Wipe off the dirt from the disc surface, or use an unscratched disc. Be sure to use a disc that contains files in a format that is supported by the unit. You tried to play a disc that is not supported by the unit. Be sure to use a disc that is supported by the unit. The unit is in USB mode. Press CD/USB to switch to Disc mode. Playback does not start immediately or from the correct point. The disc is dirty or scratched. Wipe off the dirt from the disc surface, or use an unscratched disc. The USB flash drive may not be properly connected to the unit. Connect the USB flash drive properly. Unable to play a music file stored on the USB flash drive. You tried to play files in a format that is not supported by the unit. Be sure to use a USB flash drive that contains files in a format that is supported by the unit. The unit is in Disc mode. Press CD/USB to switch to USB mode. No sound The unit is not connected to the amplifier properly. Check the connection to the amplifier. Audio is not output from the device connected to the unit's DIGITAL OUTPUT jack. The PURE DIRECT function is turned on. Turn the PURE DIRECT function off. Page 11 22 - - - - 24 23 23 12, 19, 21 24 14 23, 24 14, 19, 21 10 15 26 En

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
26
En
Refer to the table below if the unit fails to function properly. If the problem is not listed below, or if the symptoms persist after you follow the instructions below, turn off the power to the
unit by pressing
A
(Power) on the front panel, disconnect the power cord, and contact your nearest authorized Yamaha dealer or service center.
Troubleshooting
Problem
Cause
Solution
Page
Pressing
A
(Power) on the front panel
does not turn the power on.
The power cord may not be properly plugged in.
Connect the power cord firmly to the AC outlet.
11
The unit suddenly enters Standby
mode.
You did not interact with the unit for a certain amount of time after the
playback stopped and the Auto Power Standby function has kicked in.
Disable the Auto Power Standby function.
22
The disc tray does not close
completely.
A foreign object is inside the disc tray enclosure.
Check the disc tray and remove any foreign object.
—
Unable to play the inserted disc. Or, the
corresponding slot indicator on the
front panel does not light up.
The disc is scratched.
Change the disc.
—
The lens inside the unit has condensation.
Turn on the power to the unit, wait 20-30 minutes, and then try to play
the disc again.
—
The disc is set upside down.
Be sure to place the disc with its label side up.
—
The disc is dirty or scratched.
Wipe off the dirt from the disc surface, or use an unscratched disc.
24
You tried to play files in a format that is not supported by the unit.
Be sure to use a disc that contains files in a format that is supported by
the unit.
23
You tried to play a disc that is not supported by the unit.
Be sure to use a disc that is supported by the unit.
23
The unit is in USB mode.
Press CD/USB to switch to Disc mode.
12, 19, 21
Playback does not start immediately or
from the correct point.
The disc is dirty or scratched.
Wipe off the dirt from the disc surface, or use an unscratched disc.
24
Unable to play a music file stored on the
USB flash drive.
The USB flash drive may not be properly connected to the unit.
Connect the USB flash drive properly.
14
You tried to play files in a format that is not supported by the unit.
Be sure to use a USB flash drive that contains files in a format that is
supported by the unit.
23, 24
The unit is in Disc mode.
Press CD/USB to switch to USB mode.
14, 19, 21
No sound
The unit is not connected to the amplifier properly.
Check the connection to the amplifier.
10
Audio is not output from the device
connected to the unit's DIGITAL
OUTPUT jack.
The PURE DIRECT function is turned on.
Turn the PURE DIRECT function off.
15