Yamaha CDC-835 Owner's Manual - Page 20
RELAY PLAY, Disc play, Connections
View all Yamaha CDC-835 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
RELAY PLAY If you have two CDC-835s, you can enjoy any combination play of ten discs by connecting them to each other. Connections At first, determine which CDC-835 is to be used as the main unit (or the second one). Connections should be made as shown in the following figure. Main unit DIGITAL OUT COAXIAL ON OFF LINE OUT RELAY PLAY 2nd CHANGER INPUT L CONTROL 2nd MAIN R Set to "MAIN" . To amplifier L L R Remote control cable (separate purchase) R 2nd unit DIGITAL OUT COAXIAL ON OFF LINE OUT RELAY PLAY 2nd CHANGER INPUT L CONTROL 2nd MAIN R Set to "2nd" . q The 2nd/MAIN switch should be set while the units are in the power-off mode. q When the units are not connected to each other, the "2nd/MAIN" switch on the rear panel of each unit should be set to the "MAIN" position. q Be sure to set the DIGITAL OUT ON/OFF switch on the rear of each unit to the "OFF" position. q Relay play cannot be done if the DIGITAL OUT (COAXIAL) terminal of the main unit is used for the connection to the amplifier. Disc play If the power of both the units is switched on simultaneously, you can begin play from the first disc in the main unit. The operating methods are the same as the normal disc play. In the "SINGLE" disc play-mode Discs are played alternately between the two units in sequence. In the "ALL" disc play-mode After playing all discs in one unit, play will be switched to the other automatically. MAIN 1 2 3 4 5 MAIN 2nd 1 1 2nd 1 2 3 4 5 2 5 34 2 5 34 20