Yamaha CDC-845 Owner's Manual - Page 19

Display information during programming Œ  Ž Œ Shows the side of the tape and the program number for the track to be set next.  Shows the selected disc and track number. Ž Shows the total remaining time on the side of the tape.  Programmed track numbers illuminate and unprogrammed ones flash on and off. * If "A-01" does not appear in the display after the PROG button is pressed, press the TIME display mode-select button.  s Random sequential tape programming The unit will automatically program tracks on a disc in random sequential order for recording to tape. CDC-845 CDC-745 2 3, 4 3, 4 2 1 Follow step 1 - 5 on page 17. 2 RANDOM * The unit will automatically program tracks for side A and side B separately considering the tape's total time. 3 Begin recording on the tape deck and press the PLAY/PAUSE button on this unit at the same time. 4 The unit will pause at the end of side A of the tape. Turn the tape over to side B. Resume recording and, at the same time, press the PLAY/PAUSE button on this unit. Notes q Because the programmed data changes every time the RANDOM button is pressed, the amount of time remaining at the end of the tape also changes accordingly. q If the tape's length is not enough, all tracks cannot be programmed. In this case, exchange the tape for a longer one. q In step 2, you can check the program data for side A and side B. Œ  Ž Œ Shows the number of programmed tracks for each side in turn just after the automatic programming is finished, and then it is replaced by the number of the first programmed track for side A.  Shows the total time of programmed tracks for each side. Ž Shows the programmed track numbers for each side. q CD synchronized recording method can be used if your tape deck is compatible with it. In this case, in step 3 and 4, press the SYNCHRO button and then press the PLAY button on this unit's remote control transmitter. Recording automatically begins. (For details, refer to page 21.) 19