Yamaha CDX-590 Owner's Manual - Page 11

English, CDX-890, When you listen with headphones, Changing brightness of the display

Page 11 highlights

English Changing brightness of the display CDX-890, CDX-590 You can change the brightness of the display (or turn off the illumination) by pressing the DIMMER button. During play During stopped or paused Normal illumination Normal illumination Dim DIMMER Dim "OFF" * While the display illumination is off, the AUTO DISPLAY OFF indicator on the front panel is illuminated. AUTO DISPLAY OFF Dim (The AUTO DISPLAY OFF indicator lights up. In this state, if a disc is played, the display illumination will be turned off.) CDX-490 If desired, you can change brightness of the display in three degrees by pressing the DIMMER button. DIMMER Normal illumination Slightly dim Dim When you listen with headphones Connect the headphones to the PHONES jack and adjust the volume by using the OUTPUT LEVEL button. At that time, note that this adjustment will also vary the signal level output to the amplifier. CDX-890 only * If the FIXED (LINE OUT) terminals on the rear of this unit are connected to the amplifier etc., the use of the OUTPUT LEVEL button will not vary the signal level output to the amplifier. Open/close the control door CDX-890 only When it is not necessary to operate controls inside the control door, close the door. To open the door PHONES To close the door - OUTPUT LEVEL + 11

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23

11
When you listen with headphones
Connect the headphones to the
PHONES
jack and adjust the
volume by using the
OUTPUT LEVEL
button.
At that time,
note that this adjustment will also vary the signal level output to
the amplifier.
CDX-890 only
* If the FIXED (LINE OUT) terminals on the rear of this unit
are connected to the amplifier etc., the use of the
OUTPUT
LEVEL
button will not vary the signal level output to the
amplifier.
Changing brightness of the display
You can change the brightness of the display (or turn off the illumination) by pressing the
DIMMER
button.
During play
Normal illumination
Dim
“OFF”
*
While the display illumination is off,
the
AUTO DISPLAY OFF
indicator
on the front panel is illuminated.
During stopped or paused
Normal illumination
Dim
Dim
(The
AUTO DISPLAY OFF
indicator lights up.
In this state, if a disc is played, the display
illumination will be turned off.)
If desired, you can change brightness of the display
in three degrees by pressing the
DIMMER
button.
Normal illumination
Slightly dim
Dim
Open/close the control door
CDX-890 only
When it is not necessary to operate controls inside the control
door, close the door.
To open the door
To close the door
English
DIMMER
DIMMER
PHONES
AUTO
DISPLAY OFF
OUTPUT LEVEL
+
CDX-890, CDX-590
CDX-490