Yamaha CDX-E100 Owner's Manual - Page 7

English The remote control This remote control controls a whole system: not only RX-E100 but also CDX-E100. Moreover, a cassette deck (KX-E100) and MD recorder (MDX-E100) that level up your system can be operated by it. Operating buttons for each unit are explained on the pages below: Receiver, RX-E100: p.7 CD player, CDX-E100: p.15 Cassette deck, KX-E100: p.20 MD recorder, MDX-E100: p.20 Loading the batteries for the remote control 1 Remove the battery compartment cover. GETTING STARTED Notes • Use only AAA, UM-4, R03 batteries for replacement. • Be sure the polarities are correct. (See the illustration inside the battery compartment.) • Remove the batteries if the remote control will not be used for an extended period of time. • If batteries leak, dispose of them immediately. Avoid touching the leaked material or letting it come in contact with clothing, etc. Clean the battery compartment thoroughly before installing new batteries. Remote control operation range NATURAL SOUND STEREO RECEIVER RX-E100 VOLUME DISPLAY MEMORY AUTO/MAN'L PRESET/BAND PRESET/TUNING STANDBY/ON PHONES TIME ADJ TIMER BASS HOUR TREBLE MIN BALANCE MIN MAX INPUT -+ -+ LR Remote control sensor 2 Insert 4 batteries into the battery compartment. Within approximately 6 m (20 feet) 30° 30° 3 Replace the battery compartment cover. Notes • There should be no large obstacles between the remote control and the main unit. • If the remote control sensor is directly illuminated by strong lighting (especially an inverter type of fluorescent lamp, etc.), it might cause the remote control not to work correctly. In this case, reposition the main unit to avoid direct lighting. Battery replacement If you find that the remote control must be used closer to the main unit than usual, the batteries are weak. Replace batteries with new ones. E-3