Yamaha CLP-115 Owner's Manual - Page 29
Keyboard Stand Assembly - size
View all Yamaha CLP-115 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 29 highlights
ENGLISH Keyboard Stand Assembly CAUTION • Be careful not to confuse parts, and be sure to install all parts in the correct direction. Please assemble in accordance with the sequence given below. • Assembly should be carried out by at least two persons. • Be sure to use the correct screw size, as indicated below. Use of incorrect screws can cause damage. • Be sure to tighten up all screws upon completing assembly of each unit. • To disassemble, reverse the assembly sequence given below. Have a Phillips-head (+) screwdriver ready 1. Attach the side panels to the pedal box. Side panel (right) (2) Align the sides of the pedal box with the left and right side panels. Remove the following parts from the package. Assembly Parts 6 × 20 mm long screws ×4 1 4 × 20 mm tapping screws ×4 4 6 × 16 mm short screws ×4 2 Cord holders × 2 4 × 12 mm thin screws ×2 3 Main unit Side panel (left) Rear panel Side panel (right) Pedal box Bundled pedal cord inside AC power cord TIP A headphone hanger is included in the CLP-115 package. You can attach a headphone hanger on the CLP-115 to hang the headphones (page 12). L R L Side panel (left) (3) Use the four 6×20 mm long screws 1 to attach the pedal box. (1) Untie and straighten out the bundled cord attached to the bottom of the pedal box. Don't discard the twist tie, you'll need it later in step 5. 2. Attach the rear panel. (1) Secure the top of the rear panel to the side panel brackets using two 4×12 mm thin screws 3. Place the bottom edges of the rear panel on the feet's protruding edges, with the panel slightly angled as shown in the illustration. (2) Secure the bottom of the rear panel to the pedal box using four 4×20 mm tapping screws 4. CLP-115 Keyboard Stand Assembly 29