Yamaha CLP-955 Owner's Manual - Page 49

Attach the three legs A., per leg.

Get Yamaha CLP-955 PDF manuals and user guides View all Yamaha CLP-955 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 49 highlights

1 A Rectangular Pipe A Make sure that when the legs are attached that the legs are fitted to the rectangular pipe's rounded edge. A Washer 3 Spring Washer 2 10 x 60mm bolt 1 A When attaching the legs, make sure to tighten each bolt using the supplied wrench until there remains no gap between the washer, spring washer and the bolt. As you tighten the bolt, occasionally shake the leg to remove any looseness between the pipes and the leg. Z Attach the three legs (A). Use scissors or a cutter to remove the packing material in which the main unit is wrapped. Then attach the legs to the bottom of the main unit using one 10 x 60mm bolt 1 per leg. The legs (A) are identical so they can be used at any position on the unit however, please pay close attention to the illustration and ensure that the legs are properly fitted to the rectangular pipe's rounded edge. CLP-955 49

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
49
CLP-955
1
A
A
Make sure that when the legs are attached
that the legs are fitted to the rectangular
pipe’s rounded edge.
A
10 x 60mm bolt
1
Spring Washer
2
Washer
3
When attaching the legs, make sure to tighten each bolt using the supplied
wrench until there remains no gap between the washer, spring washer and the
bolt. As you tighten the bolt, occasionally shake the leg to remove any looseness
between the pipes and the leg.
A
Rectangular Pipe
Z
Attach the three legs (A).
Use scissors or a cutter to remove the packing material in
which the main unit is wrapped. Then attach the legs to the bot-
tom of the main unit using one 10
x
60mm bolt
1
per leg. The
legs (A) are identical so they can be used at any position on the
unit however, please pay close attention to the illustration and
ensure that the legs are properly fitted to the rectangular pipe’s
rounded edge.