Yamaha CRX-332 Owners Manual - Page 18
iPod/iPad, Status message, Cause, Remedy, Problem
View all Yamaha CRX-332 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
TROUBLESHOOTING iPod/iPad Note In case of a transmission error without a status message appearing in the front panel of this unit, check the connection to your iPod/iPad (see page 5). Status message Cause Remedy iPod Connecting iPod Charging This unit is in the middle of recognizing If the message continues to appear in the front panel the connection with your iPod. display, disconnect and connect the iPod again. Unknown iPod There is a problem with the signal path Connect the iPod again. from your iPod to this unit. The iPod being used is not supported by Only iPod classic, iPod nano (2nd generation and this unit. later), iPod touch and iPhone are supported. iPod This unit has recognized your iPod; however, it cannot obtain information such as elapsed time. iPod Unplugged Your iPod was removed. Connect the iPod again. Over Current The iPod being used is not supported by Disconnect the iPod and then turn the unit off and on this unit. again. Then connect supported iPod again. The iPod is connected at an angle. * Messages shown above appear only when a device is connected to the iPod dock. Page 5 5 - 5 5 Problem No sound. The iPod/iPad sounds, but you cannot operate it with the unit or the remote control. You cannot operate from the iPod/iPad. The playback information is not displayed on the front panel display. The iPod/iPad does not charge up. Suddenly the music being played back is canceled and another track starts playing without performing any operation. Cause The power of the unit is off. The iPod/iPad software version has not been updated. The iPod/iPad is in the process of connecting with the unit. The iPod/iPad is not connected correctly. The iPod/iPad is not connected correctly. The iPod/iPad is not connected correctly. The iPod/iPad you set is not compatible with the playback information display. The iPod/iPad is not connected correctly. The iPod's Shake to Shuffle function is turned on. Remedy Connect the power cable correctly. Download the latest iTunes software to update the iPod/iPad software version to the latest. Please wait for a while. Remove the iPod/iPad from the unit, then connect it again. Remove the iPod/iPad from the unit, then connect it again. Remove the iPod/iPad from the unit, then connect it again. Only iPod classic, iPod nano (2nd generation and later), iPod touch, iPhone and iPad are supported. Remove the iPod/iPad from the unit, then connect it again. Turn off the Shake to Shuffle function in the iPod's settings. Page - - - 5 5 5 5 5 - 14 En