Yamaha CRX-E400 Owner's Manual - Page 8

GETTING STARTED Setting the clock You must set the clock before you use the timer functions. The clock is based on a 24-hour system. STANDBY/ON DISPLAY HOUR MIN STANDBY/ON TIMER PHONES NATURAL SOUND STEREO RECEIVER RX-E400 VOLUME DISPLAY MEMORY AUTO/MAN'L PRESET/BAND TIMER ADJ BASS TIMER TREBLE PRESET/TUNING HOUR MIN BALANCE - + - + L R MIN MAX INPUT TIME ADJ PRESET/BAND 1 Turn on the power by pressing STANDBY/ON on the front panel, or POWER on the remote control. 2 While the power is on, press DISPLAY to display the time. 3 While holding TIME ADJ, press HOUR to set the hour. • If you want to move the time in the reverse direction, press HOUR while holding TIME ADJ and PRESET/BAND. 4 While holding TIME ADJ, press MIN to set the minutes. • If you want to move the time in the reverse direction, press MIN while holding TIME ADJ and PRESET/BAND. To display the clock Press DISPLAY. The current time appears for about 8 seconds, then the normal display returns. Some buttons and controls may not work while the current time is displayed. Note • In the event of a power failure or when the AC power cord is disconnected for more than five minutes, you must reset the clock. Adjusting the brightness of the display You can adjust the brightness of the display. If you have connected the CD player (CDX-E400), cassette deck (KX-E300), and/or MD recorder (MDX-E300) to this unit, the brightness of the displays is automatically adjusted to that of this unit. DISPLAY STANDBY/ON TIMER PHONES NATURAL SOUND STEREO RECEIVER RX-E400 VOLUME DISPLAY MEMORY AUTO/MAN'L PRESET/BAND TIMER ADJ BASS TIMER TREBLE PRESET/TUNING HOUR MIN BALANCE - + - + L R MIN MAX INPUT INPUT Press and hold DISPLAY for about two seconds so that "Dimmer ±0" appears on the display. While holding DISPLAY, turn INPUT clockwise to increase or counterclockwise to decrease brightness. Control Range: ±0 to -6 (Preset value: ±0) 6