Yamaha CXS18XLF CXS18XLF CXS15XLF Owners Manual - Page 6

Functions Front Rear q w e r y t q Dual pole sockets Compatible with commercially available speaker poles of 35 mm diameter and M20 screws. 35 mm diameter M20 screw If you use the pole socket for mounting of a satellite speaker, observe the conditions below for your safety. Subwoofer CXS18XLF CXS15XLF Speakers to be mounted Weight: 26 kg or less Height: 76.0 cm or less (CZR15 or smaller) Weight: 22 kg or less Height: 64.5 cm or less (CZR12 or smaller) Weight: 18 kg or less Height: 53.7 cm or less (CZR10 or smaller) Pole length 104 cm or less 82 cm or less 104 cm or less w Feet cups When stacking multiple speakers, align the rubber feet of the upper speaker to the feet cups of the lower one. e Wheel mounting screws NOTE • For details on installing the wheels or special precautions you should take, please refer to the corresponding manual for the wheels. • Do not install any wheels other than the SPW-1. rt [INPUT/PARALLEL] jacks These are speakON jacks (Neutrik NL4). Either r or t can be connected since they are connected in parallel inside. The speaker unit is connected to the 1+/1- contacts of the [INPUT/PARALLEL] jacks. speakON plug Insert all the way inside and turn to lock y [OUTPUT] jack This speakON jack is for use with a full-range speaker through CXS, or when using CXS in the cardioid mode. This jack receives the signals via 2+/2- of r or t and routes them to 1+/1- for output. INPUT 1+/1- r 2+/2- OUTPUT y 1+/1- (2+/2-: Unconnected) For installing the optionally available Yamaha SPW-1 wheels. To install the wheels, use these screws after removing them from the unit. Do not use the CXS once the screws are removed. This causes air leaks to occur in the enclosure, resulting in undesirable performance. 1+/1- t 2+/2- PARALLEL 6 CXS series Owner's Manual