Yamaha DC9160A Owner's Manual - Page 5

44&.#-:
130$&%63& Make sure the chimes are assembled or disassembled by at least two persons. 1 TTZ TTZ A TTZ A 2 ωδB B 3 ωδC ωδC 4 5 ωδB͓ΑͼωδC ωδB͓ΑͼωδC 6 6 1 Connect the pedal assembly to the left and right base sections. Position the pedal assembly and left/right base sections as shown in the illustration below. * The following procedure is carried out to ensure that the performer faces forward when playing the instrument. Fully loosen screws A, and then slide the pedal assembly pipe all the way into the hole on the base section. Tighten screws A to secure. After connecting the assembly pipe to the base sections, lock the casters (left and right). 2 Insert the side columns into the holes on the left and right base sections. Fully loosen screws B and insert the end of the side column pipe with the small hole on its side, all the way into the left and right side base sections. * Both left and right side columns are the same. * To make attachment of the damper and hanger sections easier, do not tighten screws B yet. 3 Set the damper. Fully loosen screws C and slide the damper onto the side columns from above so that the damper rod is positioned on the right. Slide the damper down the columns until it comes to rest on the damper rests. * To make attachment of the hanger section easier, do not tighten screws C yet. 4 Set the hanger. Slide the hanger onto the side columns from above. Slide it all the way onto the columns. 5 Tighten screws B and C. Firmly tighten screws B and C on both right and left sides and secure. 6 Set the damper pedal. Pull the damper pedal out to the front, and then hook the hook on the end of the pull rod onto the damper rod. At this time, pull down on the pull rod knob to hook onto the damper rod, then release the pull rod knob. * Do not press down on the damper pedal. Doing so engages the damper and the sound columns cannot be hung.