Yamaha DSP-AZ1 Owner's Manual - Page 68
Setting the manufacturer code, MACRO ON/OFF
View all Yamaha DSP-AZ1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 68 highlights
REMOTE CONTROL FEATURES Setting the manufacturer code You can control other components by setting a manufacturer code. A code can be set up in each component control area except for the OPTN area. The Yamaha code is factory preset for TUNER, MD/TAPE, CD-R, CD and DVD. TRANSMIT RE-NAME CLEAR LEARN MACRO MACRO OFF ON SYSTEM POWER STANDBY V-AUX TUNER PHONO CABLE SAT MD/TAPE CD-R CD D-TV/LD VCR 1 VCR 2 VCR3/DVR DVD TITLE 6CH INPUT SOURCE DISPLAY MENU SELECT SEARCH ENTER SOUND CHAPTER POWER REC STOP PAUSE PLAY 2, 5 1 3 4 1 Select the source component you want to preset by using the input selector buttons. 2 Press and hold LEARN for about 3 seconds by using a ballpoint pen or similar object. "SETUP" and the selected component name appear alternately in the display window. LEARN SETUP DVD Cautions • If you do not press any button within 30 seconds during step 3, the setup process is canceled. If this happens, start over from step 2. • Press LEARN for at least 3 seconds, otherwise the learning process is started. 3 Press / to select the name of your component's manufacturer. You will find the names of most worldwide audio-video manufacturers in alphabetical order in the display window. 4 Press POWER (or any other button) on the remote control while pointing it at the component to check if you have set up the code correctly. If the component cannot be controlled by the remote control, try entering another code for the same manufacturer. 5 Press LEARN again to exit from the setup mode. LEARN Cautions • Supplied remote control does not store all the manufacturer codes for commercially available AV components (including Yamaha AV components). Therefore it may not work to operate your AV component. If operation is not possible with any of the manufacturer codes, program the new remote control function with the Learn feature (see pages 68 and 69) or use the remote control for the component. • Only one manufacturer code can be set for each input selector button. • If you have already programmed a remote control function for a button, the function by learning or macro programming takes priority over the setup manufacturer code's function. • "ERROR" appears in the display window under the following circumstances: 1 when pressing more than one button at once 2 when MACRO ON/OFF, 10KEY/DSP or PARAMETER/ SET MENU is switched to another position ENTER E-66