Yamaha DTX430K Owner's Manual - Page 52
Pad Gate Group, 8. Fast Blast Timer
View all Yamaha DTX430K manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 52 highlights
Setting Parameters using Menu Mode 6-7. Pad Gate Group Steps: MENU ([KIT] + [SONG]) [6] [7] Setting 6-8. Fast Blast Timer Steps: MENU ([KIT] + [SONG]) [6] [8] Setting Setting Setting Using the following procedure, you can set which groups of pads the drum module should consider when deciding whether or not you are playing the correct pattern in Pad Gate training (page 37). 1. While holding the [KIT] button, press the [SONG] but- ton to activate Menu Mode. 2. Press number button [6] to select the Training Settings parameter group. 3. Press number button [7] to select the Pad Gate Group parameter. 4. Select a new setting using the corresponding number button ([1] to [4]). The available settings are as follows. Number button [1] [2] [3] [4] Setting Description All pads Group type 1 Group type 2 All notes Any pad will produce a sound and be scored, as long as the timing of your drumming is correct. The kit will be separated into five groups-Kick, Snare, Toms, Cymbals, and Hi-hat. In order for your drumming to produce sounds and be scored, you must strike pads from the same group as those from the practice drum pattern and do so in time. More difficult than Group type 1, this setting splits each of the toms and each of the cymbals into individual groups. In addition, the hi-hat pad and the hihat controller are also treated separately. With this setting, you must play the exact same practice drum pattern as the drum module. NOTE • The evaluation method set using this parameter applies only to Pad Gate training. Other types of training are not affected. • The higher the setting, the more difficult the training. Using the following procedure, you can set the timer for Fast Blast training sessions (page 39). When the timer counts down to zero after the start of a training session, it will automatically end the training. 1. While holding the [KIT] button, press the [SONG] but- ton to activate Menu Mode. 2. Press number button [6] to select the Training Settings parameter group. 3. Press number button [8] to select the Fast Blast Timer parameter. 4. Select your preferred practice time using the corre- sponding number button ([1] to [10/0]). The available settings are as follows. Number button [1] [2] [3] [4] [5] [6] [7] [8] [9] [10/0] 10 seconds 30 seconds 60 seconds 90 seconds 120 seconds 150 seconds 180 seconds 300 seconds 480 seconds 600 seconds Setting NOTE The timer set using this parameter applies only to Fast Blast training. Other types of training are not affected. 52 DTX400K/DTX430K/DTX450K Owner's Manual