Yamaha ELB-01 Owner's Manual - Page 181

Problem Possible Cause and Solution EFFECTS The Initial Touch function does not operate. Adjust the Initial Touch settings in the Voice Condition display (page 42). The Reverb effect is not applied to the desired Voice sections, even when the Reverb setting in the Voice Condition display Page 1 set to maximum. Increase the Reverb depth for the desired Voice sections in Reverb display. The Rotary Speaker effect cannot be heard, even Rotary Speaker must be selected first in Voice Condition display. when the [ROTARY SP SPEED] button in the DISPLAY SELECT section is on. ACCOMPANIMENT The pitch in the Single Finger mode does not change, Single Finger mode will only produce notes when played within a fixed octave even when pressing different keys of the keyboard. interval on the Lower keyboard. If notes with the same letter name are pressed outside of that range, the chords that are sounded will share the same pitch. While an Intro/Ending pattern is automatically playing, Since the Accompaniment chords play automatically one after another, the the Lower keyboard does not produce any sound, Lower keyboard is designed not to produce any sound during the playback of even when the keys are played. an Intro/Ending pattern. The Accompaniment cannot be heard even when an appropriate Accompaniment type is selected and the rhythm has been started. • The Accompaniment volume may have been set to 0. Be sure to raise the Accompaniment volume in the Rhythm Condition display (page 70). • All Accompaniment parts may be set to off (mute). Set the desired part on (page 68). The harmony notes of the Melody On Chord function The Upper keyboard has been set to sound only Lead Voices. Increase the cannot be heard. volume of the Upper Keyboard Voices. REGISTRATION MEMORY Certain functions have not been memorized to Registration Memory. Some functions cannot be memorized. Refer to page 98. MUSIC DATA RECORDER Recording or playback cannot be performed. • The part buttons may have been turned off. Turn the desired part to REC or PLAY. • The performance data is too large. The maximum limit for recording performance data is 1 MB. • The media is write-protected. Cancel the write-protect. • The media/folder may contain EL-format songs. You cannot record to the media/folder that contains EL-format songs. Create a new folder and record the song to it. Recording is stopped before the performance is finished. • The amount of recorded data on the media is close to the maximum limit. Either use another media or delete the data of unnecessary songs. • When you overwrite the song, the length of a subsequently recorded part cannot exceed the length of the previously recorded parts. Delete the previously recorded song, then record again (page 121). • The performance data is too large. The maximum limit for recording performance data is 1 MB. An error message appears while entering a folder name or song name. • The song/folder name is too long. The capacity is 50 characters. • The song/folder name may be an invalid name. Refer to page 124. • The path name is too long. The capacity of the path name is 234 characters. Reduce the layer or shorten the song/folder name to shorten the path. The rhythm does not start at the beginning of a The M.D.R. is designed so that the rhythm cannot be started at the very recording, or stops in the middle of the performance. beginning of a recording. If you wish to use the rhythm, start it after the time indicator appears in the display. The floppy disk cannot be formatted when you want to Recognizing an unformatted disk takes a few seconds after it is inserted. format an unformatted disk. Wait about 30 seconds, then try to format again. The notes of the recording are "stuck" and sound continuously. During playback, you may have removed the USB flash memory or floppy disk. Whenever you wish to stop playback, always press the [STOP] button before removing the media. 10 Appendix ELB-01 Owner's Manual 181