Yamaha HD-300 HD-300 Owners Manual - Page 31

Advanced Settings (Settings) You can change advanced settings on the Settings screen. Press the [SETTING] button to call up the Settings screen. Press the [EXIT] button to exit from the screen. Select an item using the CURSOR [-][3] buttons, and then use the [-]/[+] buttons, or the dial to change values. To return the selected item to its default value, press both [-]/[+] buttons simultaneously. Items in the Settings screen are as follows. Name Standard Pitch Metronome Sound Metronome Pattern Sound Back Time Pre Time Shift Rec Post Time Shift Rec Bluetooth BD Address (*) LCD Contrast Foot Pedal Auto Power Off Language Firmware Version (*) Description Settings Sets the standard pitch. 430.0 - 450.0 Hz Sets the metronome sound. Peck: This is the same tone used by the HD-200. Click: This is a mechanical metronome tone. Beep: This is an electronic metronome tone. Sets the metronome pattern (page 23). All: The metronome plays back all beats. Alternate: The metronome plays back beats so that multiple click sounds are not doubled at the same timing. Specifies the duration until the sound produced by the HD-300 turns off after there are no more input sounds when the Sound Back feature is turned on. Short: approx. 2 sec. Long: approx. 4 sec. Specifies the number of seconds recorded before the [REC] button is pressed while in Time Shift Recording mode. 3 - 10 sec. Specifies the number of seconds until a recording automatically stops after starting or extending a recording in Time Shift Recording mode. 5 - 20 sec. Sets the Bluetooth communication mode. Off: Use this to disable Bluetooth communication. On: Use this to connect to a paired device. Pairing: Use this to switch to pairing mode. Displays the MAC address for the HD-300 - as a Bluetooth device. Adjusts the contrast of the LCD. 0 - 20 Sets functions of the pedal connected to the [FOOT PEDAL] jack. Volume: This adjusts the main volume. Hold: This produces the same effect as the [HOLD] button. Start/Stop: This produces the same effect as the [START/ STOP] button. Rec: This produces the same effect as the [REC] button. Enables/disables the Auto Power Off function. Disable: This disables the Auto Power Off function. Enable: This enables the Auto Power Off function. NOTE The amount of time that elapses before the power is automatically turned off depends on the type of power being used. This is set to 30 minutes for battery power, and two hours when using an AC adaptor. Sets the language of alert messages and file names that appear in training mode. English, Japanese Displays the firmware version. - (*) Items with this mark are for display only and cannot be changed. HD-300 Owner's Manual 31