Yamaha HTR-5440 Owner's Manual - Page 28

PLAYING A SOURCE Selecting a DSP Program You can enhance your listening experience by selecting a DSP program. Refer to "SOUND FIELD PROGRAM" for details about each program. y • Make sure that the sound effect is turned on (see page 25). I On the remote control 1 2 1 Press AMP(TUNER) on the component selector. 2 Press PRG+ or PRG- repeatedly to select the desired program. The name of the selected program appears for a moment and the selected DSP program indicator lights up on the display. DIGITAL DSP MOVIE THEATER 1 BASS EXT. DSP program name I On the front panel STANDBY /ON D I G I TA L SURROUND BASS TREBLE BALANCE -+ -+ L R SPEAKERS A B ON OFF D I G I TA L VOLUME PROGRAM EFFECT PRESET/TUNING PHONES S VIDEO VIDEO L AUDIO R OPTICAL A/B/C/D/E PRESET /TUNING FM/AM EDIT MEMORY TUNING MODE MAN'L/AUTO FM AUTO/MAN'L MONO INPUT MODE INPUT 6CH INPUT (HTR-5450) SILENT VIDEO AUX PROGRAM / Press PROGRAM l or h repeatedly to select the desired program. The name of the selected program appears for a moment and the selected DSP program indicator lights up on the display. DIGITAL DSP MOVIE THEATER 1 BASS EXT. PROGRAM DSP program name y • If desired, adjust the delay time and the sound output level of each speaker. (Refer to "DELAY TIME AND SPEAKER OUTPUT LEVELS" on page 37 for details.) Notes • Choose a DSP program based on your listening preference, and not on the name of the program. The acoustics of your listening room affect the DSP program. Minimize the sound reflections in your room to maximize the effect created by the program. • When you select an input source, this unit automatically selects the last DSP program used with that source. • When you set this unit in the standby mode, the current source and DSP program are memorized and are automatically selected when you turn on the power again. • If a Dolby Digital or DTS signal is input when the input mode is set to AUTO, the DSP program automatically switches to the appropriate decoding program. • When a monaural source is being played with PRO LOGIC/ NORMAL or PRO LOGIC/ENHANCED, no sound will be heard from the main speakers and the rear speakers. Sound can only be heard from the center speaker. However, if "CENTER SP" in the SET MENU is set to NON, the center channel sound is output from the main speakers. • When a source connected to the 6CH INPUT jack of this unit is selected, the digital sound field processor cannot be used. • HTR-5450 only When 96-kHz sampling digital signals are input to this unit, the DSP program cannot be selected. In this case, the sound is reproduced as normal 2-channel stereo. 24