Yamaha HTR-5450 Owner's Manual - Page 49
Setting the Manufacturer Code, To use a second and third VCR
View all Yamaha HTR-5450 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 49 highlights
INTRODUCTION PREPARATION BASIC OPERATION ADVANCED OPERATION Setting the Manufacturer Code You can set the code for the manufacturer of your component after pressing the component selector buttons other than AMP(TUNER). 1 Turn on your component to be used. 2 Press one of the component selector buttons which corresponds to the component to be controlled. 3 Press both VOLUME buttons (u/d) at the same time for about four seconds. The indicator flashes twice. PRESET REMOTE CONTROL I To use a second (and third) VCR You can control a second (and third) VCR in the CBL/SAT and DVD MENU modes if a cable TV or satellite tuner, or DVD player is not being used. Note • In order to set a second (and third) VCR in the DVD MENU mode, it is necessary to first set up the code for an LD player in the DVD/LD mode. 1 Turn on the VCR to be used. 2 Press CBL/SAT or DVD MENU on the component selector. 3 Press both VOLUME buttons (u/d) at the same time for about four seconds. The indicator flashes twice. 4 Use the numeric buttons to enter the four-digit manufacturer code for the component to be used. Make sure that the indicator flashes twice. If the indicator does not flash, repeat step 3 and re-enter the code. 5 Press POWER (or any other button) on the remote control to check if you have set the code correctly. If your component cannot be controlled with the remote control, try setting another code for the same manufacturer. Notes • You can set only one code for one mode. • In the DVD/LD and DVD MENU modes: Be sure to press DVD/LD on the component selector before entering the code for the DVD/LD player. You cannot set the code for a DVD player after pressing DVD MENU on the component selector. The code set in the DVD/LD mode is also simultaneously set in the DVD MENU mode. • If your component does not respond to any of the codes listed for the manufacturer, use the original remote control supplied with your component. 4 Use the numeric buttons to enter the four-digit code for the second (and third) VCR. Make sure that the indicator flashes twice. If the indicator does not flash, repeat step 3 and re-enter the code. 5 Press POWER (or any other button) on the remote control to check if you have set the code correctly. If the VCR cannot be controlled with the remote control, try setting another code for the same manufacturer. APPENDIX English 45