Yamaha MDX-M5 Owner's Manual - Page 34
Troubleshooting, ADDITIONAL INFORMATION
View all Yamaha MDX-M5 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 34 highlights
ADDITIONAL INFORMATION Troubleshooting If the unit fails to operate normally, check the following points to determine whether the fault can be corrected by the simple measures suggested. If it cannot be corrected, or if the fault is not listed in the SYMPTOM column, disconnect the power cord and contact your authorized YAMAHA dealer or service center for help. When you repair the unit, the CRX-M5 may be needed. For details, contact and make sure your authorized YAMAHA dealer or service center. SYMPTOM The unit does not respond to operations. The unit does not work normally. Playback is not possible. Recording is not possible. The MD cannot be removed when partially inserted. Excessive noise. The remote control transmitter does not work. TV functions strangely when the remote control used. CAUSE MD is dirty or damaged. MD is damaged ("DISC ERROR" appears in the display). There is an influence of strong external noise (lightning, excessive static electricity, etc.) or a misoperation was performed while using the unit. Moisture on the laser pickup. The power is OFF. The disc has been loaded incorrectly. An unrecorded (blank) MD was loaded ("BLANK DISC" appears in the display). The disc is protected from recording ("PROTECTED" appears in the display). A pre-mastered MD is loaded ("PLAY ONLY" appears in the display. The source is not connected correctly. The input setting is incorrect. The recording level is too low. The digital output level of the digital source is too low. There is not enough blank space left on the MD. If the AC power cord was unplugged or there was a power outage during recording, that recording may be lost. The carriage lock function has been activated. The unit is too close to a television or other component. The batteries of the remote control transmitter are too weak. The remote control is too far away or is being used at incorrect angle. Direct sunlight or lighting (of an inverter type of fluorescent lamp etc.) is striking the remote control sensor of the main unit. The remote control is being used near TV set with a remote control sensor. REMEDY Replace the current disc with a new one. Turn the unit off and disconnect the AC power from the wall outlet. After about 30 seconds have passed, connect the power and try again. Leave the unit switched ON and wait 20 to 30 minutes for the moisture to evaporate before trying to play the disc. Press STANDBY/ON or POWER to turn the unit on. Reload the disc with the label side facing up, and the arrow pointing toward the disc insertion slot. Insert a recorded MD. Slide the record-protect tab to the closed position. Load a recordable MD. Check all connections again. Press REC INPUT repeatedly to select the correct input source. Turn REC LEVEL to adjust the recording level. Set the digital output level of the digital source to "MAX." Load a recordable MD with fewer recorded tracks, or erase unnecessary tracks from the current MD. If recording was interrupted, try recording again starting from the beginning. Insert the MD completely, then press ) to eject it. Place the unit further away from the television or other component. Replace the batteries with new ones. Use within 6 m and 60° radius. Change the position of the main unit. Relocate this unit away from the TV or cover TV's remote control sensor. E-28