Yamaha MG8 Owner's Manual - Page 16
Master Control PHANTOM +48 V Switch, 2TR IN Control, ST Master LEVEL Control - 2fx power supply
View all Yamaha MG8 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
Front & Rear Panels Master Control Section 8 2 3 REVERB HALL 1 REVERB HALL 2 REVERB ROOM 1 REVERB ROOM 2 REVERB STAGE 1 REVERB STAGE 2 REVERB PLATE DRUM AMBIENCE KARAOKE ECHO VOCAL ECHO CHORUS 1 CHORUS 2 FLANGER PHASER AUTO WAH DISTORTION 1 7 6 5 4 1 PHANTOM +48 V Switch This switch toggles phantom power on and off. If you set the switch on, the mixer supplies power to all channels that provide XLR mic input jacks (CHs 1, 2, 3/4, 5/6). Set this switch on ( ) when using one or more condenser microphones. NOTE When this switch is on, the mixer supplies DC +48 V power to pins 2 and 3 of all XLR-type MIC INPUT jacks. • Be sure to leave this switch off ( ) if you do not need phantom power. • When tuning the switch on ( ), be sure that only condenser mics are connected to the XLR input jacks (CHs: 1 to 5/6). Devices other than condenser mics may be damaged if connected to the phantom power supply. Note, however, that the switch may be left on without problem when connecting to balanced dynamic microphones. • To avoid damage to speakers, be sure to turn off amplifiers (or powered speakers) before turning this switch on or off. We also recommend that you turn all output controls (ST Master LEVEL Control, etc.) to minimum settings before operating the switch, to avoid risk of loud noises that could cause hearing loss or device damage. 2 RETURN Control Adjusts the level of the signal sent from the RETURN jacks (L (MONO) and R) to the Stereo bus. NOTE If you supply a signal to the RETURN L (MONO) jack only, the mixer outputs the identical signal to both the L and R Stereo buses. 3 2TR IN Control Adjusts the level of the signal sent from the 2TR IN jack to the Stereo bus. 4 ST Master LEVEL Control Adjusts the signal level to the ST OUT jacks. 5 C-R/PHONES LEVEL Control Controls the level of the signal output to the PHONES jack and the C-R L and R jacks. 6 Level Meter This LED display shows the level of the signal fed to the Stereo bus. The "0" point corresponds to the standard output level. The indicator lights up red when the output hits the clipping level. 7 POWER Indicator This indicator lights up when the mixer's power is ON. 8 DIGITAL EFFECT • PROGRAM Dial Selects the internal digital effect to be applied. You can select from 16 effects, as shown in the table. No Program 1 REVERB HALL 1 2 REVERB HALL 2 3 REVERB ROOM 1 4 REVERB ROOM 2 5 REVERB STAGE 1 6 REVERB STAGE 2 7 REVERB PLATE 8 DRUM AMBIENCE 9 KARAOKE ECHO 0 VOCAL ECHO A CHORUS 1 B CHORUS 2 C FLANGER D PHASER E AUTO WAH F DISTORTION Parameter REVERB TIME REVERB TIME REVERB TIME REVERB TIME REVERB TIME REVERB TIME REVERB TIME REVERB TIME DELAY TIME DELAY TIME LFO FREQ LFO FREQ LFO FREQ LFO FREQ LFO FREQ DRIVE 16 MG8/2FX