Yamaha MRX-70 MRX-70 OWNERS MANUAL - Page 7

HOW TO CLEAR SIGNALS PROGRAMMED BY THE LEARNING OPERATION By using the RESET switch, signals that you have programmed to a learning key or to a preset learning key can be canceled. When the RESET switch is used for cancellation, learning keys are then unoccupied by programming, and preset learning keys return to their preset status. To cancel the programming of a certain key, or to return it to the preset programming (applicable only to preset learning keys) 1. To cancel key programmings, set the mode-select switch to "ALL". 1 A. •B NORM NB* *ALL RESET I I To return to preset programmings, set the mode-select switch to "NB". A. *B NORM NB* *ALL RESET III 2. Set the LEARN-NORM switch to the "LEARN" position. LEARNED ERROR RESET LEARN NORM 400 3. Press the RESET switch using the point of a mechanical pencil, etc. The LEARNED and ERROR indicators will illuminate for 15 seconds. LEARNED ERROR RES MIN NORM I 013 4. Press and then release the learning key (or preset learning key) for which you want the programmed signal to be canceled. The LEARNED indicator's illumination and the ERROR indicator's illumination will then stop. Then, when the cancellation is finished, the LEARNED indicator will illuminate for one second. This indicates the completion of the cancellation process. To cancel two or more programmings, repeat steps 2 and 3. NOTE If a learning key (or a preset learning key) is not pressed within 15 seconds after the RESET switch is pressed, this unit will automatically return to the status that was in effect before the RESET switch was pressed. 7