Yamaha MS45DR MS45DR Owners Manual - Page 10
Installing the Monitor Speakers - e drum monitor
View all Yamaha MS45DR manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
Satellite speaker [Rear] y [INPUT] jack This jack is used to connect the satellite y speaker to the subwoofer. Installing the Monitor Speakers CAUTION The MS45DR satellite speakers can be attached to straight vertical pipes of 1.5-inch (38.1-mm) diameter. These speakers cannot be attached to curved pipes or any pipes of different diameter sizes. 1. First insert the speaker mount of the satellite speaker into the hole q of the pipe clamp, then tighten the wing bolt. Satellite speaker q Pipe clamp Speaker mount Wing bolt 2. As shown in Figure A, slowly insert one leg of your drum rack through the hole w of the pipe clamp. When you finish adjusting the position, tighten the wing bolt as shown in Figure B. CAUTION Be sure to attach the satellite speakers to the leg of the drum rack slowly and deliberately to avoid injury. NOTE Be sure to tighten the wing bolts securely. [Figure A] [Figure B] 3. See Figure C. Place the Subwoofer speaker on a flat floor. 4. Connect the satellite speakers, subwoofer speaker, and the drum module via the included combination cable as shown in Figure C. WARNING Use only the supplied power cord. CAUTION When setting up the product, make sure that the AC outlet you are using is easily accessible. If some trouble or malfunction occurs, immediately turn off the power switch and disconnect the plug from the outlet. w Drum rack leg Wing bolt 3