Yamaha MX-1 Owner's Manual - Page 6
Control Parts And Their Functions, Rear Panel, Front Panel - mx 1 power amplifier
View all Yamaha MX-1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
CONTROL PARTS AND THEIR FUNCTIONS FRONT PANEL SPEAKERS REAR PANEL LEVEL LEVEL INPUT REMOTE CONTROL ( PRE AMP ) INPUT REMOTE CONTROL ( PRE AMP ) POWER switch/indicator (POWER) Press this switch to switch ON the power. The indicator will illuminate while the power is ON. Press the switch again to switch OFF the power. Note the following cautions. q Before switching ON the power, be sure to set the volume control of the pre-amplifier to the lowest setting in order to avoid damage to the speakers. q The speaker-protection circuit functions to mute speaker sound reproduction for a few seconds after the power is switched ON. SPEAKERS switches Because one or two speaker systems can be connected to this unit, these switches allow you to select speaker system A or B, or both at once. Input level controls (LEVEL) These controls adjust the level of signals input to this unit. Normally set these controls to the "10" (maximum) position, and adjust the whole sound output level with the VOLUME control of the pre-amplifier. However, if your speakers' permissible music input power is not high enough or sounds from the speakers are distorted, turn these controls counterclockwise to decrease the level. STANDBY mode (For Europe model only) If the REMOTE CONTROL (PRE AMP) connector on the rear panel of this unit is connected to the corresponding connector of the pre-amplifier (CX-1 or CX-2), by turning the power off with the POWER switch of the pre-amplifier, this unit is switched to the STANDBY mode. (In this mode, the indicator over the POWER switch is half illuminated.) 6 Note To turn the power off completely, disconnect the AC power plug from the wall outlet.