Yamaha MY16-MD64 MY16-MD64 Owners Manual - Page 4
Introduction, Part Names and Functions, Panel - madi
View all Yamaha MY16-MD64 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
ENGLISH Introduction Introduction Thank you for purchasing the Yamaha MY16-MD64 MADI interface card. The MY16-MD64 is a MADI card for use with compatible Yamaha professional audio equipment. Using the MY16-MD64 with a maximum of three MY16-EX Yamaha I/O expansion cards allows transmission and reception of up to 64 channels (in/out) of uncompressed digital audio signals when running at a sampling frequency of 48 kHz or 44.1 kHz. About the host devices in which the MY16MD64 can be installed Before installing the card in a host device, please refer to the Yamaha Pro Audio web site for the latest information on the compatible host devices in which the card can be installed. Yamaha Pro Audio web site: http://www.yamahaproaudio.com/ About the MADI channel number Ch1-16 will be assigned to the MY16-MD64. Ch17-32, Ch3348 and Ch49-64 will be assigned to the MY16-EX in the order of connection. Installation information Please refer to the owner's manual supplied with the host device for installation information. As well as securing the card in place, the fixing screws at the left and right of the card function as electrical grounds. Be sure to screw them in tightly. Accessories Owner's Manual Part Names and Functions ■ Panel 1 2 3 A [NEXT MY16-EX IN][NEXT MY16-EX OUT] Connectors These RJ-45 connectors can be connected via an Ethernet straight cable (CAT5e or higher category) to the [MASTER SIDE IN] or [MASTER SIDE OUT] connector of the Yamaha MY16-EX I/O expansion card for transmission and reception of the audio and word clock signals. NOTE: Use an STP (Shielded Twisted Pair) cable to prevent electromagnetic interference. Using a UTP (Unshielded Twisted Pair) cable may cause noise or cut off sound. Also, be sure to attach the ferrite core included with the MY16-EX to a location close to the cable plug connected to the [NEXT MY16-EX OUT] connector. 4 B [OPTICAL IN][OPTICAL OUT] Connectors These are SC connectors that can be connected via a multimode fiber optic cable to other MADI devices for transmission and reception of audio and control signals. NOTE: About the cable • Use a multimode fiber optic cable with 50-micron core/ 125-micron cladding diameters, or 62.5-micron core/ 125-micron cladding diameters. • Cables up to 2,000 meters in length can be used. About the connector • Use SC duplex connectors. • Attach the supplied rubber cap to the connectors on the card to prevent dust from settling on the connectors when the cable is not connected. 4 MY16-MD64 Owner's Manual