Yamaha N-803D R-N803/N-803D Firmware Update Installation Manual - Page 1
Yamaha N-803D Manual
View all Yamaha N-803D manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1 highlights
EN AV17-0052 R-N803 R-N803D Update Guide There are two ways to update the firmware on the R-N803 and R-N803D: connect to the Internet to update directly, or use a USB storage device. Please see the Owner's Manual for more information on updating via the Internet. This guide explains how to update using a USB storage device. See the R-N803 page on the Yamaha website for more information on issues that have been resolved in the firmware update and new functions that have been added. Preparing the firmware Updating the firmware 1 Have a USB storage device ready for use. The USB storage device must fulfill the following conditions. • Required conditions for USB storage device - Supports mass storage - Formatted as FAT16 or FAT32 - Does not feature encryption - Blank (no data stored on the device) 2 Download the latest firmware from the Yamaha website. See the R-N803 page on the Yamaha website. 3 Decompress the downloaded file. The firmware you downloaded is a compressed file. The decompressed file (R0445-****.bin) is the firmware data file for update (the "****" will vary, depending on the version). 4 Save the decompressed file (R0445-****.bin) to the root folder (topmost folder) in the USB storage device. Now you're ready to update. A (POWER) DISPLAY RETURN PHONES SPEAKERS A B YPAO MIC USB 5V 1A DIMMER DISPLAY MODE MEMORY CLEAR BAND PRESET TUNING INPUT BASS TREBLE BALANCE LOUDNESS FLAT -30dB SELECT PUSH - ENTER L R RETURN CONNECT PURE DIRECT VOLUME USB jack DISPLAY SELECT/ENTER NOTICE Be absolutely sure not to turn off the power while the firmware is updating. If the power is turned off during updating, the unit may fail to start up again. 1 Press A (POWER) on the unit to switch off the power. 2 Insert the USB storage device that you have prepared into the USB jack. 3 Press A (POWER) while holding down RETURN. "ADVANCED SETUP" will appear in the display. 4 Turn the SELECT/ENTER knob until "UPDATE · · · USB" is shown on the display. Note When "UPDATE · NETWORK" is shown on the display, press SELECT/ENTER to display "UPDATE · · · USB". 5 Press DISPLAY. The firmware will start updating. Once the update has completed, "UPDATE SUCCESS" will be shown on the display. 6 Press A (POWER) to turn off the power. 7 Pull out the USB storage device. This completes the firmware update. Wait for at least 5 seconds after the firmware update has finished, before turning on the power. The next time you turn on the power, the unit will operate with the updated firmware.