Yamaha NS-35E Owner's Manual - Page 2

CONNECTIONS TO YOUR AMPLIFIER Before making connections, make sure that the amplifier is switched off. Speaker (R) Speaker (L) REMOVING THE FRONT COVER The front cover is fastened to the enclosure at four points, and can be removed if desired. To remove the cover, hold on to both sides and slowly pull straight away from the speaker. To reattach, line up the four pegs on the inside surface of the cover with the four corresponding holes on the speaker and push gently. Loosen Black (-) Tighten Red (+) Speakers output terminals of the amplifier Red Amplifier Note When the cover is removed, take care not to touch the speaker units with your hands or to exert excessive force with tools. s Connections q Connect the screw-type input terminals at the rear of the speakers to the speaker output terminals of your amplifier with the provided speaker cables. q One side of the speaker cable is red and the other side is black. Connect the (+) terminals on both the amplifier and the speakers using this red side. Connect the (-) terminals on both components using the black side of the cable. q Connect one speaker to the left (marked L) terminals of your amplifier, and another speaker to the right (marked R) terminals, making sure not to reverse the polarity (+, -). If one speaker is connected with reversed polarity, the sound will be unnatural and lack bass. Procedure: Œ Loosen the terminal knob.  Remove approx. 10 mm insulation from the speaker cable and insert the bare wire end properly into the terminal hole. Ž Tighten the knob.  Test the security of the connection by tugging lightly on the cable at the terminal. Note Do not let the bare speaker wires touch each other as this could damage the speaker and/or the amplifier. SPECIFICATIONS Type 2-way bass reflex speaker system Driver 16 cm cone woofer 3 cm dome tweeter Impedance 6 ohms Frequency Response 50 Hz - 30 kHz Nominal Input Power 60 W Maximum Input Power 150 W Sensitivity 90 dB/2.83 V/m Crossover Frequency 3 kHz Dimensions (W x H x D 233 x 392 x 275 mm Weight 6.3 kg Accessories Speaker cable (4 m) x 2 q Specifications subject to change without notice due to product improvements. q Care should be taken not to exceed the input power values noted above. V585580