Yamaha NS-45E Owner's Manual - Page 2
Connection To Your Amplifier, Placing The Speakers, Attaching The Stands - speaker system
View all Yamaha NS-45E manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 2 highlights
CONNECTION TO YOUR AMPLIFIER BEFORE MAKING CONNECTIONS, MAKE SURE THAT THE AMPLIFIER IS SWITCHED OFF. Speaker (R) Speaker (L) s CONNECTIONS ● Connect the screw-type input terminals at the rear of the speakers to the speaker output terminals of your amplifier with the provided speaker cords. ● One side of the speaker cord is red and the other side is black. Connect the (+) terminals on both the amplifier and the speakers using this red side. Connect the (-) terminals on both components using the black side of the cord. ● Connect one speaker to the left (marked L) terminals of your amplifier, and another speaker to the right (marked R) terminals, making sure not to reverse the polarity (+, -). If one speaker is connected with reversed polarity, the sound will be unnatural and lack bass. Loosen Black (-) Red Tighten Red (+) Speaker output terminals of the amplifier Procedure: 1 Loosen the terminal knob. 2 Insert the bare speaker wire end properly into the terminal hole. [Remove approx. 10 mm (3/8") insulation from the speaker cord.] 3 Tighten the knob. 4 Test the security of the connection by pulling lightly the cord at the terminal. Amplifier Note Do not let the bare speaker wires touch each other as this could damage the speakers or the amplifier, or both of them. ATTACHING THE STANDS Stand x 8 Screw x 16 Leg x 8 When placing the speakers, be sure to use the stands to increase stability. Use the 8 specified holes located on the base of the speaker. PLACING THE SPEAKERS ● Place the speakers on a sturdy vibration-free surface. If you cannot obtain good bass quality when the speakers are placed directly on the floor, insert a block etc. between the speakers and the floor. ● Better stereo images will be obtained when the speakers are slightly angled in towards the listeners. Procedure: 1 Put a screw through the inside hole on the stand, and screw it into the speaker at one of the outside holes on the base of the speaker. At this time, screw it untightly so that the stand can still be moved. 2 Put another screw through the outside hole on the stand, and screw it into the inside hole on the base of the speaker. 3 Tighten both of the screws firmly. 4 Attach a leg to the bottom of the end portion of the stand. 5 Attach the other stands to the other corners of the base of the speaker in the same way and confirm that all 4 stands have been firmly attached. Note Bacause these speakers are not a magnetically shielded type, there may be some influence on a TV picture depending on the type of TV or the placement of the speakers. In such a case, place the speakers apart from the TV. Note Be carefull not to apply force to the side of the speaker, otherwise the speaker may fall causing damage to the speaker or personal injury. Printed in Indonesia V500530