Yamaha NS-C60 Owner's Manual - Page 2

CONNECTION TO YOUR AMPLIFIER BEFORE MAKING CONNECTIONS, MAKE SURE THAT THE AMPLIFIER IS SWITCHED OFF. s CONNECTIONS ● Connect the push-type input terminals at the rear of the speaker to the speaker output terminals of your amplifier with the provided speaker cables. ● One side of the speaker cable is marked by a white line. Connect the (+) terminals on both the amplifier and the speakers using this white-marked side. Connect the (-) terminals on both components using the unmarked side of the cable. If connected with reversed polarity, the sound will be unnatural and lack bass. Procedures: Œ Press the tab on the terminal down, as shown in the figure.  Insert the bare wire end properly into the terminal hole. [Remove approx. 5 mm (1/4") insulation from the speaker cable.] Ž Remove your finger from the tab to allow it to lock snugly on the cable's wire end.  Test the security of the connection by tugging lightly on the cable at the terminal. NS-C60 White line White line White line Press tab Center speaker output terminals of the amplifier Note Do not let the bare speaker wires touch each other as this could damage the speaker and/or the amplifier. SPECIFICATIONS Type 2 way bass-reflex speaker system Magnetic-shielding type (EIAJ) Speaker Unit 8 cm cone woofer (JA0858) x 2 Tweeter (JA05S0) x 1 Input Terminal Push-type Nominal Impedance 6 ohms Frequency Response ...........60 Hz - 20 kHz (-10 dB) Nominal Input Power 40W Music Input Power 80W Sensitivity 88 dB/w/m Dimensions (WxHxD 435 x 100 x 221 mm (17-1/8" x 4" x 8-11/16") Weight 2.2 kg (4 lbs. 13 oz.) Accessories Speaker cable (4m) x 1 Slip-prevention pad x 4 * Specifications subject to change without notice due to product improvements. * Care should be taken not to exceed the input power values noted above.