Yamaha NS-E103 Owner's Manual - Page 2

SETTING UP THE SPEAKERS s Mounting the speakers on a wall The speaker can be mounted on a wall by using the holes provided on the speakers' back panel. For the upright mounting, only one hole is provided. As for the side-long mounting, two holes are provided. Be sure to use these two holes as a set. The hole(s) on the speaker's back panel is arranged so that the speaker can be mounted in either of the two configurations shown by the following figures. Upright mounting Side-long mounting 60mm For upright mounting For side-long mounting For side-long mounting Wall or wall support Fasten wood screws onto a firm wall or wall support as shown in the figure, and set the mounting holes onto the protruding screws. Diam. 4-5 mm Min. 12 mm 4-5 mm Wood screw (Available at a hardware store) Make sure that the screw is caught securely at a narrow part of the hole . WARNING: * Each speaker weighs 1.4 kg (3 lbs. 1 oz.). Do not mount them on thin plywood or soft wall surface material, as the screws may come out of the flimsy surface, causing the speakers to fall down and be damaged, or result in personal injury. * Do not fasten the speakers to walls with nails, adhesives, or other unsound hardware. Long-term use and vibrations may cause them to fall down. * To avoid accidents resulting from tripping over loose speaker cables, fix them to the wall. SPECIFICATIONS Type Full-range bass-reflex speaker system Magnetic shielding type Speaker Unit 10 cm cone full-range Nominal Impedance 6 ohms Frequency Response 70 Hz - 20 kHz Nominal Input Power 25W Maximum Input Power 80W Sensitivity 90 dB/W·m Dimensions (WxHxD 180 x 220 x 101 mm (7-1/16" x 8-11/16" x 4") Weight 1.4 kg (3 lbs. 1 oz.) Accessories Speaker cable (10m) x 2 * Specifications subject to change without notice due to product improvements. * Care should be taken not to exceed the input power values noted above. Printed in China V 228210